User's Manual
Table Of Contents
- Contents
- Before You Begin
- Chapter 1 - Using the Computer
- Chapter 2 - Connecting and Configuring the CN50
- Chapter 3 - Developing and Installing Applications
- Chapter 4 - Troubleshooting andMaintaining the CN50
- Appendix A - Specifications
- Appendix B - Default Settings
- Appendix C - Keypads and Keystrokes
- Appendix D - Imager Configuration Bar Codes
Chapter 1 — Using the Computer
CN50 Mobile Computer User’s Manual 13
Aligning the Touch Screen
If the touch screen does not respond when you tap it with the stylus,
you may need to calibrate the screen.
To calibrate the touch screen
1 Tap Start > Settings > the Systems tab > Screen.
2 Tap Align Screen and follow the instructions to align the screen.
3 Click ok.
If you are unable to align the touch screen, you may need to cold boot
the CN50. For help, see “Cold Booting the CN50” on page 58.
Understanding the Status LEDs
The CN50 has three status LEDs.
Status LEDs
Note: If the touch screen is so out of alignment that you cannot
open the Start menu, you can try to align the screen menu using
the keypad. For help, see the next procedure.
Key status LED
Notification LED
Good Read LED