Installation Guide

OWNER / INSTALLER INSTRUCTIONS

SCHEDULE:

1. Set first zone for watering, push gold pin in slot on yellow dial at

desired on time. For each additional 12 minutes of watering time add

one pin without skipping a slot.

NOTE:

The silver pin located at midnight turns the skipper wheel, it does not

activate an on time.

2. To change zones, leave one slot blank for each 12 minutes of off time.

There must be at least one blank space after each on time (gold pin

or pins) to change zones.

3. Repeat step 1 and 2 until all zones are scheduled for watering.

Multiple schedules can be set.

4. Set time of day. Turn yellow dial CLOCKWISE until correct time is at

end of silver time pointer. Do not turn silver time pointer.

5. To skip days: The black skipper wheel should have all pins up (pull

away from skipper wheel) for daily operation. Press pin in for days of

NO operation. Turn wheel COUNTERCLOCKWISE until today’s day is

opposite (14) arrow.

6. Put selector switch in AUTO. This switch can be used to turn system

ON for manual operation or OFF for overriding the program to prevent

sprinkling as desired without affecting the program.

PAGE 1
® OWNER / INSTALLER INSTRUCTIONS SCHEDULE: 1. Set first zone for watering, push gold pin in slot on yellow dial at desired on time. For each additional 12 minutes of watering time add one pin without skipping a slot. NOTE: The silver pin located at midnight turns the skipper wheel, it does not activate an on time. 2. To change zones, leave one slot blank for each 12 minutes of off time. There must be at least one blank space after each on time (gold pin or pins) to change zones. 3.
PAGE 2
TROUBLESHOOTING DISCONNECT POWER AT CIRCUIT BREAKER BEFORE SERVICING PROBLEM Water stays on: POSSIBLE CAUSE(S) SOLUTION(S) 1. All models - Check selector switchshould be in AUTO. Place selector switch in AUTO. 2. All models - No blank space or yellow dial. Note that blank spaces provide off operation. Be sure there is at least one blank space on yellow dial between each watering zone. Water stays off: 1. Power not applied to timer.