Instructions / Assembly

ADJUSTING THE SENSOR DIP SWITCH SETTINGS
The occupancy sensor features 4 DIP switches, one sensitivity setting and three time delay settings. Each setting can be set to an up position or down position that
configures the DIP Switch setting to a specified sensitivity or time delay. Follow this procedure to adjust the DIP switch settings.
1. Adjust the sensitivity level DIP Switch (1). The Up position sets the sensitivity to 100%, while the down position adjusts the sensitivity level to 50%.
2. Adjust the time delay DIP switches (2-4). Refer to the table below to set a time delay.
NOTE: After the sensor detects no motion in the coverage area, it will delay a user-configured amount of time before turning lights off. See the table below to
determine how to set the desired time delay for the sensor.
3. Install the front on the sensor and secure with the screws.
FIGURE 9. Configuring DIP Switch Settings
Table 1. Time Delay Options
Time Delay Option Slide Slide Slide
2 Switch Setting 3 Switch Setting 4 Switch Setting
to to to
Set for 15 Seconds Down Position Down Position Down Position
Set for 5 Minutes Down Position Down Position Up Position
Set for 10 Minutes Down Position Up Position Down Position
Set for 15 Minutes Down Position Up Position Up Position
Set for 20 Minutes Up Position Down Position Down Position
Set for 25 Minutes Up Position Down Position Up Position
Set for 30 Minutes Up Position Up Position Down Position.
TROUBLESHOOTING
LED flashes but lights do not turn ON: Make sure wiring is correct.
Make sure that the power to the sensor has been ON continuously for 1 minute.
Cover the light sensor lens to simulate darkness. If light turns ON adjust the light level.
Check the light fixture.
Lights will not turn OFF: Make sure other sources of infrared energy in the area, such as turbulent air from a heating or cooling supply,
are not causing the sensor to detect motion. Adjust accordingly.
Verify the time delay DIP switches are set properly.
Check sensor wiring.
158--01288
LIMITED TWO YEAR WARRANTY
If within the warranty period specified, this product fails due to a defect in material or workmanship, Intermatic Incorporated will repair or replace it, at its sole option, free of charge. This warranty is extended to the original
purchaser only and is not transferable. This warranty does not apply to: (a) damage to units caused by accident, dropping or abuse in handling, acts of God or any negligent use; (b) units which have been subject to
unauthorized repair, opened, taken apart or otherwise modified; (c) units not used in accordance with instructions; (d) damages exceeding the cost of the product; (e) sealed lamps and/or lamp bulbs, LED’s and
batteries; (f) the finish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear; (g) transit damage, initial installation costs, removal costs, or reinstallation costs.
INTERMATIC INCORPORATED WILL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR
CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS OR IMPLIED WARRANTIES. ALL IMPLIED
WARRANTIES, INCLUDING THE WARRANTY OF MERCHANTABILITY AND THE WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, ARE HEREBY MODIFIED TO EXIST ONLY AS CONTAINED IN THIS
LIMITED WARRANTY, AND SHALL BE OF THE SAME DURATION AS THE WARRANTY PERIOD STATED ABOVE. SOME STATES DO NOT ALLOW LIMITATIONS ON THE DURATION OF AN IMPLIED
WARRANTY, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU.
This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased, or (b) completing a warranty claim on line at www.intermatic.com. This warranty is made by:
Intermatic Incorporated, Customer Service 7777 Winn Rd. Spring Grove, Illinois 60081-9698. For warranty service go to: http://www.intermatic.com or call 815-675-7000.