Instructions / Assembly

ManualsBrandsIntermatic ManualsElectricalIOS Series 800-Watt High Bay 360-Degree Occupancy Sensor, White

ADJUSTING THE SENSOR DIP SWITCH SETTINGS

The occupancy sensor features 4 DIP switches, one sensitivity setting and three time delay settings. Each setting can be set to an up position or down position that

conﬁgures the DIP Switch setting to a speciﬁed sensitivity or time delay. Follow this procedure to adjust the DIP switch settings.

1. Adjust the sensitivity level DIP Switch (1). The Up position sets the sensitivity to 100%, while the down position adjusts the sensitivity level to 50%.

2. Adjust the time delay DIP switches (2-4). Refer to the table below to set a time delay.

NOTE: After the sensor detects no motion in the coverage area, it will delay a user-conﬁgured amount of time before turning lights off. See the table below to

determine how to set the desired time delay for the sensor.

3. Install the front on the sensor and secure with the screws.

FIGURE 9. Conﬁguring DIP Switch Settings

Table 1. Time Delay Options

Time Delay Option Slide Slide Slide

2 Switch Setting 3 Switch Setting 4 Switch Setting

to to to

Set for 15 Seconds Down Position Down Position Down Position

Set for 5 Minutes Down Position Down Position Up Position

Set for 10 Minutes Down Position Up Position Down Position

Set for 15 Minutes Down Position Up Position Up Position

Set for 20 Minutes Up Position Down Position Down Position

Set for 25 Minutes Up Position Down Position Up Position

Set for 30 Minutes Up Position Up Position Down Position.

TROUBLESHOOTING

LED ﬂashes but lights do not turn ON: Make sure wiring is correct.

Make sure that the power to the sensor has been ON continuously for 1 minute.

Cover the light sensor lens to simulate darkness. If light turns ON adjust the light level.

Check the light ﬁxture.

Lights will not turn OFF: Make sure other sources of infrared energy in the area, such as turbulent air from a heating or cooling supply,

are not causing the sensor to detect motion. Adjust accordingly.

Verify the time delay DIP switches are set properly.

Check sensor wiring.

158--02213REF

LIMITED WARRANTY

Warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased or (b) completing a warranty claim online at www.intermatic.com. This warranty is made by: Intermatic

Incorporated, 1950 Innovation Way, Suite 300, Libertyville, IL 60048. For additional product or warranty information go to: http://www.Intermatic.com or call 815-675-7000.