User Guide

Page 25 of 35
Programming the Controller (continued)
After setting the day group and execution time, you will
need to choose which channels you want to control,
and what you want those channels to execute. The
master controller can send commands to modules to
turn ON to full brightness, turn OFF, turn ON to a pre-
programmed brightness level (other than full ON), or
turn a SCENE ON.
Setting the Channels to Control, and Setting the Lighting Effect
(The Channel numbers and Dimmer Bars should
already be flashing.)
5. Press the Channel ON button of the channel that you
wish to program. (NOTE: For Channels 7-12, press the
SHIFT button). You may select more than one channel.
6. (See Fig 14e on page 26) Set the lighting level by
pressing and holding the ALL OFF or ALL ON buttons
until the bars indicate the approximate desired light
level.
(See Fig 14f on page 26) If you would like to control
SCENES (the light levels that were established when
you originally set up the modules), press and release
ALL ON. Four dimming bars are displayed with spaces
in between each. Pressing ALL ON a second time will
selections.
7. (See Fig 14g on page 26) Press ENTER to accept your
selections. Pressing ENTER will increase the event
number. Up to 28 events can be programmed into the
controller.