User Guide

Page 14 of 35
Setting Astronomic Function (continued)
Fig 7 – SUNSET default time may be different than shown
above. Press ENTER to accept the default time.
Creating a Network
NOTE: Creating a network refers to assigning modules to
the master controller. All modules must be assigned to the
master controller before any programming or remote control
functions can be accomplished.
NOTE: Devices should be plugged into modules before
adding modules to the network. Devices (for example,
lamps) should be turned to the ON position.
INCLUDE Modules to a Network
1. (See Fig 8a) Press and release the INCLUDE button.
The INCL icon and TRANSMITTING message will
begin to flash, indicating that the controller is ready to
include modules to the system. (If INCL and
TRANSMITTING stop flashing, the controller has “timed
out”. The INCLUDE button must be pressed again).