Install Instructions

1. Mount Intermatic Time Control within enclosure.
2. Select knockouts to be used. Remove the inner
(1/2”) knockout by inserting a screwdriver in
the slot and carefully punch knockout loose.
Remove slug. If the 3/4” knockout is required,
remove the outer ring with pliers after removing
the 1/2” knockout. Smooth edges with a knife if
necessary.
3. Place enclosure in desired mounting location
and mark the three mounting holes.
4. Drill holes for #10 screws, start screws in holes.
5. Place enclosure over screws and tighten
screws.
6. Connect conduit hubs to conduit before
connecting the hubs to the enclosure. After
inserting hubs into enclosure, carefully tighten
hub lock nut. Do not over-torque.
7. Wire in accordance with National and Local
Electrical Code requirements.
GROUNDING: Intermatic Time Controls and this
enclosure are made of plastic construction and do
not require a ground connection. Also, they do not
require bonding in pool applications.
DIMENSIONS:
Overall, w/mounting tabs: 10” x 6.5” x 3.75” deep
Base exterior: 8” x 5” x 2.4” deep
Base interior: 7.5” x 4.5” x 2” deep
Door exterior: 8.7” x 5.5” x 1.4” deep
Weight: 1lb
158--01588
INTERMATIC INCORPORATED
Spring Grove, IL 60081-9698
www.intermatic.com
INSTALLATION: