Instructions / Assembly

2
Digtial Landscape Timer
INITIAL SETUP
Overview
Upon first use, you must enable the battery and then set the Date, Time, and Location.
If you make a mistake during any of the programming steps, press the RESET button (I), then press the SET button (D) to
cycle through the timer menus until you locate the error and then correct the entry.
Enabling the Battery
1. Remove the pull tab (M) from the battery holder, if
present. See FIG. 1.
2. When the display shows 12:00 AM, the timer is
ready for initial set up. See FIG. 2. If 12:00 AM does
not display, perform a Factory Reset or see the
Troubleshooting section.
Note: The timer may be set while unplugged. The display
turns OFF after 1 minute of inactivity to save battery.
Press any button to turn the display back ON.
M
FIG. 1 Removing the Pull Tab
Performing a Factory Reset
To clear any programming or reset the timer at any time,
perform these steps:
1. Press and continue to hold the ON/OFF button (F).
2. Using a paperclip, press and hold the RESET button (I)
for 5 seconds and then release.
3. Keep holding the ON/OFF button (F) until ‘CLR’
appears on the screen.
4. Release the ON/OFF button (F). When you see 12:00
AM displayed, your timer is ready for programming.
See FIG. 2.
AM
SET PROG ON/OFF
F
I
FIG. 2 Performing a Factory Reset
Setting the Time, Date, and Location
Upon initial use, you can easily program these timer settings
in succession by completing the steps in this section.
If there is not a blinking 12:00 AM on the screen, press the
RESET button (I) to place the timer in Set-Up mode.
1. Turn the selector knob (H) to select the correct hour of
the day. Press SET (D). Repeat to select the minute of
the day. See FIG. 3.
2. Turn the selector knob (H) to select the correct YEAR.
Press SET (D). See FIG. 4.
3. Turn the selector knob (H) to select the correct MONTH.
Press SET (D). See FIG. 4.
4. Turn the selector knob (H) to select the correct DATE.
Press SET (D). See FIG. 4.
5. Turn the selector knob (H) to select the correct Daylight
Savings Time setting. The options are OFF, US/CAN,
and Mex.
a. If in Hawaii or Arizona, select OFF. Press SET (D).
b. If you live in a part of Mexico that observes
US/Canada Daylight Savings Time, select US/CAN.
Press SET (D).
CLOCK
PM
SETPROGON/OFF
H
D
I
FIG. 3 Setting the Time
YEARDATE
MONTH
FR
SETPROGON/OFF
H
D
FIG. 4 Setting the Date