User's Manual Part 2

38 I-Wave Installation Guide

Connecting the Heater Switch to Control Temperatures

Overview

The primary means of controlling the heater is using the Hand-Held Controller. If there is no

Hand-Held Controller in the system, the heater switch provides an alternate method.

This Switch can be also used in conjunction with the Hand-Held Controller to provide maximum

temperature limits for the pool and spa. Control by this Switch is primary over the Hand-Held.

Procedure

Wire the heater thermostats to the blue connectors visible

on the front of the Valve/Pump Switch, as shown.

Set limits on the heaters themselves, so that when

the Switch powers the heaters, they will reach the

temperatures you have set.

Make temperature adjustments at the heaters themselves.

If Connecting an External Timer:

Overview

You can add an external timer to a circuit, converting it from

“on-demand” control to timer control. External timers are

available from Intermatic but are not included with the I-

Wave system. When connected to the system, the external

timer powers Relay 1 on and off according to its time

settings.

Procedure

Connect your timer to Relay 1 on the back of the Valve/

Pump Switch Mechanism, as shown in the circled area of

the illustration at the right.