User's Manual Part 1

8 I-Wave Installation Guide
Copyright © 2006 Intermatic, Inc.
Valve/Pump Switch (P42343ME)
Designed for aftermarket and retrot applications, the P4243ME is
most suited for controlling up to two different circuits associated with
pool/spa combinations but can also be used to control all the equipment
typically needed in connection with water features, water gardening,
solar heating, and other similar applications. This unit snaps into almost
any Intermatic enclosure and features two 3HP double pole relays,
one of which can be controlled by an external timer, 24 volt supply for
up to three valve actuators, automatic HIGH/LOW water temperature
selector, heater connection circuit, and push button control for each
load with indicator lights on the face of the control. In addition, the unit
has connections for a hard-wired or wireless remote and a master switch
controller.
120 or 208-240 Volt Input Voltage
Controls up to three valve actuators
Switches heater thermostat
Remote control capabilities
Shipping Weight — 3 lbs. (1.4 kg)
Agency Approval — CSA/C-US
•
•
•
•
•
•
CONTACT RATINGS – EACH CIRCUIT
17A Resistive, 120/240 VAC., 50/60 Hz
1.5 HP @ 120 VAC., 50/60 Hz
3.0 HP @ 240 VAC., 50/60 Hz
10 Amp Tungsten, 120/240 VAC, 50/60 Hz
•
•
•
•
24-Volt Valve Actuator (PE24VA)
Designed with quality in mind, Intermatic’s 24-volt valve actuators
provide reliable control of 2-way and 3-way diverter valves for pool/
spa combinations and water features. The water ow can be altered
for specic applications through the adjustable cam, which rotates
diverter valves to multiple degree settings. The cam settings can be
easily adjusted by simply removing the lid. These valve actuators are
compatible with all pool/spa valves currently offered in the industry and
will retrot into all pool/spa control systems.
24VAC Input Voltage
Automates compatible diverter
valves for pool/spa combos
Adjustable cam rotates diverter
valves to multiple degree settings
•
•
•
Designed to operate most 2-way and 3-way diverter
valves
Shipping Weight - 3 lbs. (1.4 kg)
Agency Approval - CSA/C-US
•
•
•
Panel-Mounted Transceiver (PE650) and Antenna (0000000)
The main function of the Panel-Mounted Transceiver is to take commands from
the Wireless Hand-Held Transceiver and hand them off to two mechanisms
(P1353ME and/or P4243ME) in the I-Wave Enclosure box. This unit can control:
One P1353ME unit and one P4243ME unit
Two P1353ME units
Two P4243ME units
In cases where the two devices are too far apart for direct communication, a
Transceiver Repeater Module (HA04C) will relay commands between the two
devices. Shown here with its removable antenna (0000000).
•
•
•