User's Manual Part 2

30 I-Wave Installation Guide
Copyright © 2006 Intermatic, Inc.
Setting Mode
Overview
Determine the mode that would be best for your installation, then select it using the instructions
provided below.
Procedure
NOTE: If you don’t press a button within 60 seconds
while setting Mode, the control will save current
settings and return to normal operating mode.
With a small pointed tool (i.e., pen, pencil,
screwdriver, etc.,), press and hold the <MODE>
button for about 5 seconds until the display
shows SET MODE and the Mode Number
blinks.
Use the <Arrow> buttons to cycle through all
ve available modes. Each circuit output will
be dened on the display as you cycle through
the available modes.
Once the desired mode number is displayed,
press and release the <ENTER> button. This
saves the mode number to memory and exits SET MODE programming.
Setting Time of Day
Overview
This procedure makes sure that timer-controlled actions will occur at the right time.
Procedure
NOTE: If you don’t press a button within 60 seconds
while setting Time of Day, the control will save
current settings and return to normal operating mode.
Press and release the <PROGRAM> button. The
displayed time will start to blink, and the program
menu will display Set Clock.
Use the <Arrow> buttons to change the time.
NOTE: Check the AM and PM indicator to make
sure your setting is correct.
When the time is set, you have two choices:
Press and release the <ENTER> button to save and exit programming.
Press and release the <PROGRAM> button to save and go on to the next programming
feature.
1.
2.
3.
1.
2.
3.
•
•
<Mode> button
<ENTER> button
“SET MODE”
<Arrow>
buttons
Circuit outputs will
be defined
Mode
Number
blinks
<Mode> button
<ENTER> button
“SET MODE”
<Arrow>
buttons
Circuit outputs will
be defined
Mode
Number
blinks
<PROGRAM>
button
Program Menu
Displayed Time
<Arrow>
buttons
AM/PM Indicator
<PROGRAM>
button
Program Menu
Displayed Time
<Arrow>
buttons
AM/PM Indicator