User's Manual Part 2

28 I-Wave Installation Guide

Mode 2 — (Pump High, Pump Low, Aux3)

Circuit one and two are dedicated single pole

outputs for a two-speed pump load. Circuits one and

two will never be ON at the same time, consistent

with a two-speed pump application. Circuit

three is single pole circuit for a generic load, and

independent of circuits one and two..

Mode 3 — (Pump, Aux2, Cleaner Pump)

Circuit one and three are dedicated single pole

outputs for a single speed pump working with a

pressure side cleaner pump. Circuit three will never

come on unless circuit one is on for at least one

minute, consistent with a pressure side cleaner

pump. Circuit two is a single pole circuit for a

generic load, independent of circuits one and three..

Figure 4-4Figure 4-4

NOTE: This drawing illustrates

that only one leg is broken, with

the other leg going directly to

load, whether 120V or 240V.

NOTE: This drawing illustrates

that only one leg is broken, with

the other leg going directly to

load, whether 120V or 240V.

Figure 4-5Figure 4-5

NOTE: This drawing illustrates

that only one leg is broken, with

the other leg going directly to

load, whether 120V or 240V.

NOTE: This drawing illustrates

that only one leg is broken, with

the other leg going directly to

load, whether 120V or 240V.