User's Manual Part 2

48 I-Wave Installation Guide
Copyright © 2006 Intermatic, Inc.
What to check How to run the check
TROUBLESHOOTING —
What to do if it doesn’t work
✔
Check that protection
for pool cleaner pump is
working.
Mode 3 and 4
Check wireless reception all
around the yard.
If any dead spots are located, install
Repeaters. See page 41 of this manual.
Check that the Fireman’s
Switch is working (if
installed).
Press the ON/OFF button on the Three-
Circuit Clock Mechanism (P1353ME) to
power OFF the pump.
Watch for the time display to count down
the interval you have programmed.
1.
2.
Re-program the Fireman’s Switch
timing. See page 33 of this manual.
Check that the Freeze Sensor
is working (if installed).
Place the freeze sensor in a cup of ice.
Wait for the temperature of the sensor to
approaches that of the ice.
Verify that the heater has come on.
1.
2.
3.
Re-program the Freeze Sensor. See
page 34 of this manual.
Check that the Three-Button
Wired Remote Control is
working (if installed)
Press each of the three buttons on the Wired
Remote Control.
Verify that the functions controlled by those
circuits activate properly.
1.
2.
If any of the circuits don’t work, check
your wiring for that circuit.
Check that the External Timer
is working (if installed)