User's Manual Part 2

46 I-Wave Installation Guide

Press the <5> button to select MORE OPTIONS. A new screen will

appear, as shown at the right.

Press the <1> button on the new screen to select MODE 3/4 ON.

NOTE: This button toggles between ON and OFF.

That’s all there is to it. When Mode 3/4 is set to ON:

The system will automatically turn the cleaner pump OFF any time the spa mode is

activated, protecting the cleaner pump.

If the owner switches to pool mode or to the high-speed pump mode, the system waits

30 seconds before powering ON the cleaner pump, making sure there is adequate water in

the system.

Using Two Hand-Held Controllers to Operate the System

When two or more Hand-Held Controllers are being used to operate a system, each will

synchronize itself to the other according to whatever function the other controller has activated.

For example, if you press the <1> button on one controller, the following will happen:

Circuit 1 at the control center will toggle on or off, depending on its current state.

The number 1 will appear along the top of the Hand-Held Controller’s screen.

Then, a few seconds later, the number 1 will also appear along the top of the second

Hand-Held Controller’s screen.

The owner can add up to 5 Hand-Held Controllers to a system.

Manually Turning Equipment On and Off

At the Control Center

For service purposes, the ve circuits and the pool/spa actuators can be operated manually at the

Control Center.

Simply press any of the circuit buttons on either the Three-Circuit Clock or the Valve/Pump

Switch mechanisms to toggle between ON and OFF.

Any manual OFF/ON controlling will be reected on the screen of the Hand-Held Controller.

•

LEARN VER x

1 MODE 3/4

2 READY FOR ADD

5 PREVIOUS OPTIONS

C EXIT

LEARN VER x

1 MODE 3/4

2 READY FOR ADD

5 PREVIOUS OPTIONS

C EXIT