User's Manual Part 2

Six: Programming the Hand-Held Transmitter 45
Providing a brighter solution.™
On the Hand-Held you are adding to the network:
Press the <5> button to select MORE OPTIONS. A new screen
will appear, as shown at the right.
Press the <2> button on the new screen to select READY TO
ADD. The screen refreshes and displays only the line 2 READY TO
ADD.
Promptly, on the Hand-Held that is already part of the network, press
the <1> button to select INCLUDE NODE. After a few seconds, the
word SUCCESS should appear on the screens of both units.
Press the <CHLR> button on both Hand-Held Controllers to exit
programming mode. The left side of the screen of both Controllers
will say STAT OK, indicating that the procedure has been successful.
NOTE: The rst Hand-Held you link to the Control Center is considered the PRIMARY controller
and all other units are SECONDARY. The PRIMARY controller must be used to “introduce” or
link any additional Hand-Held units to the Control Center.
Programming to Protect a Pool Cleaner Pump
When you installed and wired the system, you may have included a cleaner pump along with a
spa (Mode 3) or with a two-speed lter pump (Mode 4).
You will want to make sure this pump is never powered on when the system is in spa mode.
The system can accommodate these two scenarios.
Press any button on the Hand-Held Remote to wake it from sleep.
(The unit goes to sleep to conserve battery life when it has been idle
for 30 seconds.)
Press and hold the <P/S> and <CHLR> buttons at the same time for
about 5 seconds. This will put the device in programming mode, as
shown at the right.
3.
a.
b.
4.
5.
1.
2.
LEARN VER x
1 MODE 3/4
2 READY FOR ADD
5 PREVIOUS OPTIONS
C EXIT
LEARN VER x
1 MODE 3/4
2 READY FOR ADD
5 PREVIOUS OPTIONS
C EXIT
LEARN VER x
2 READY FOR ADD
LEARN VER x
2 READY FOR ADD
LEARN VER x
1 MODE 3/4
2 READY FOR ADD
5 PREVIOUS OPTIONS
C EXIT
SUCCESS
LEARN VER x
1 MODE 3/4
2 READY FOR ADD
5 PREVIOUS OPTIONS
C EXIT
SUCCESS
STAT
OK
POOL
72
ºF SET
P 72
S 85
STAT
OK
POOL
72
ºF SET
P 72
S 85
LEARN VER x
1 INCLUDE NODE
2 ADD TO GROUP
3 RESET NODE
4 RESET CONTROLLER
5 MORE OPTIONS
C EXIT
LEARN VER x
1 INCLUDE NODE
2 ADD TO GROUP
3 RESET NODE
4 RESET CONTROLLER
5 MORE OPTIONS
C EXIT