User's Manual Part 2

42 I-Wave Installation Guide
Copyright © 2006 Intermatic, Inc.
Installing and Configuring Repeaters When Necessary
Plug a Transceiver Repeater Module (HA04C) into any electrical outlet that is located where
you have determined a reception problem can be solved.
If necessary, press any button on the Hand-Held Remote to wake it
from sleep. Because you are at a location in between the control
center and the problem area, the screen display on the Hand-Held
will look like the example on the right.
Press and hold the <P/S> and <CHLR> buttons at the same time for
about 5 seconds. This will put the device in programming mode, as
shown at the right.
Press the <1> function button to select INCLUDE NODE. The screen
refreshes and displays only the line 1 INCLUDE NODE, as shown.
Push the black button on the Repeater. The word SUCCESS appears
at the bottom of the Hand-Held’s screen as shown.
Press the <2> function button on the Hand-Held to select ADD TO
GROUP. The screen refreshes and displays only the line 2 ADD TO
GROUP.
Push the black button on the base of the Panel-Mounted Transceiver.
The screen returns to the full screen with the word SUCCESS at the
bottom, as shown.
Press the <CHLR> button on the Hand-Held Remote to exit
programming mode. When you now carry the Hand-Held Remote in
the problem area, you will now see the words STAT OK on the left
side of the screen.
The repeater is now part of the network. You can add more repeaters as necessary.
1.
2.
3.
4.
5.
6.
7.
8.
STAT
OK
POOL
72
ºF SET
P 72
S 85
STAT
OK
POOL
72
ºF SET
P 72
S 85
LEARN VER x
1 INCLUDE NODE
2 ADD TO GROUP
3 RESET NODE
4 RESET CONTROLLER
5 MORE OPTIONS
C EXIT
LEARN VER x
1 INCLUDE NODE
2 ADD TO GROUP
3 RESET NODE
4 RESET CONTROLLER
5 MORE OPTIONS
C EXIT
LEARN VER x
1 INCLUDE NODE
LEARN VER x
1 INCLUDE NODE
LEARN VER x
1 INCLUDE NODE
2 ADD TO GROUP
3 RESET NODE
4 RESET CONTROLLER
5 MORE OPTIONS
C EXIT
SUCCESS
LEARN VER x
1 INCLUDE NODE
2 ADD TO GROUP
3 RESET NODE
4 RESET CONTROLLER
5 MORE OPTIONS
C EXIT
SUCCESS
LEARN VER x
2 ADD TO GROUP
LEARN VER x
2 ADD TO GROUP
LEARN VER x
1 INCLUDE NODE
2 ADD TO GROUP
3 RESET NODE
4 RESET CONTROLLER
5 MORE OPTIONS
C EXIT
SUCCESS
LEARN VER x
1 INCLUDE NODE
2 ADD TO GROUP
3 RESET NODE
4 RESET CONTROLLER
5 MORE OPTIONS
C EXIT
SUCCESS