User's Manual Part 2

Six: Programming the Hand-Held Transmitter 41
Providing a brighter solution.™
Push the black button on the base of the Panel-Mounted Transceiver.
The screen returns to the full screen with the word SUCCESS at the
bottom, as shown.
Press the <2> function button to select ADD TO GROUP. The screen
refreshes and displays only the line 2 ADD TO GROUP.
Push the black button on the base of the Panel-Mounted Transceiver.
The screen returns to the full screen with the word SUCCESS at the
bottom, as shown.
Press the <CHLR> button on the Hand-Held Remote to exit
programming mode. On the left side of the screen, you will see the
words STAT OK.
The two devices are now linked together within the network you have
installed.
NOTE: If the two devices have not successfully reset or linked together — and you are seeing only
the word STAT on the left side of the screen — it’s likely that old programming still exists in either
device. Carefully repeat the two procedures above. If the problem persists, contact Intermatic
Customer Service.
Testing I-Wave Reception
At the heart of the I-Wave system is Z-wave™ wireless technology, which makes it easy to add
makes use of Transceiver Repeater Modules (HA04C) to ensure that no
problems in reception occur. Signal reception between Hand-Held
Controllers and the Control Center is affected by distance (about 100 feet,
direct line of sight) and by physical obstacles (like brick walls or
structures). However, by plugging in repeaters where necessary, it’s no
problem to span distances or overcome obstacles.
Test reception by walking around the yard with the Hand-Held Remote
and look on he screen to see if there are any areas where STAT OK
changes to STAT (which means the Hand-Held and the Control Center
are no longer communicating). If you identify any location where you are
out of range, you need to install and congure a repeater between the
location and the Control Center.
4.
5.
6.
7.
LEARN VER x
1 INCLUDE NODE
2 ADD TO GROUP
3 RESET NODE
4 RESET CONTROLLER
5 MORE OPTIONS
C EXIT
SUCCESS
LEARN VER x
1 INCLUDE NODE
2 ADD TO GROUP
3 RESET NODE
4 RESET CONTROLLER
5 MORE OPTIONS
C EXIT
SUCCESS
LEARN VER x
2 ADD TO GROUP
LEARN VER x
2 ADD TO GROUP
LEARN VER x
1 INCLUDE NODE
2 ADD TO GROUP
3 RESET NODE
4 RESET CONTROLLER
5 MORE OPTIONS
C EXIT
SUCCESS
LEARN VER x
1 INCLUDE NODE
2 ADD TO GROUP
3 RESET NODE
4 RESET CONTROLLER
5 MORE OPTIONS
C EXIT
SUCCESS
STAT
OK
POOL
OO
ºF SET
P OO
S OO
STAT
OK
POOL
OO
ºF SET
P OO
S OO
Transceiver Repeater Module
(HA04C)
Transceiver Repeater Module
(HA04C)