User's Manual Part 1

6 I-Wave Installation Guide
Copyright © 2006 Intermatic, Inc.
Section 1:
System Overview
The Intermatic I-Wave Pool/Spa Wireless Control System brings wireless control to a new level of
simplicity and affordability. What makes the system distinctive is that it is:
Easy to Use — with simple, push button controls and a clear, easy-to-read display panel
Everything You Need — providing, in its standard conguration, the functionality and
control called for in nearly every installation.
Modular — components snap in and out of the enclosure as needed to simplify installation
and repair, and to make customization simple for the installer. No need for the technician
to spend hours troubleshooting a circuit board…just snap in a replacement.
Dependable — with Z-Wave
®
technology that lets you plug inexpensive repeaters into an
electrical outlet to relay signals in any part of the site with dead spots. Z-Wave
®
technology
eliminates intermittant signal problems experienced with many other systems.
Cost Efciency — a superior system, easier to install and maintain, with better
dependability, and at a cost that’s competitive with any other system available.
The standard conguration for the I-Wave Pool/Spa Wireless Control System conguration is
shown in Figure 1-1. You can order individual components for a custom conguration or system
as indicated.
•
•
•
•
•
Figure 1-1Figure 1-1
Valve/Pump Switch (P4243ME), can control
up to 2 different pool/spa circuits and up
to 3 valve actuators. Can also be ordered
separately.
Valve/Pump Switch (P4243ME), can control
up to 2 different pool/spa circuits and up
to 3 valve actuators. Can also be ordered
separately.
Hand-Held Transceiver (PE950).
Up to 5 units can be used with an
I-Wave system. Additional units
can be ordered separately.
Hand-Held Transceiver (PE950).
Up to 5 units can be used with an
I-Wave system. Additional units
can be ordered separately.
Transceiver Repeater Module (HA04C)
plugs into electric outlet to eliminate
wireless interference and dead spots.
Rated for indoor or outdoor use.
Additional units can be ordered.
Transceiver Repeater Module (HA04C)
plugs into electric outlet to eliminate
wireless interference and dead spots.
Rated for indoor or outdoor use.
Additional units can be ordered.
Panel-Mounted Transceiver (PE650).
Removable anntenna (0000000)
can be ordered separately
Panel-Mounted Transceiver (PE650).
Removable anntenna (0000000)
can be ordered separately
I-Wave Steel Outdoor Enclosure
(PE40000), weatherproof, and with
plenty of room to add additional
sawitch mechanism if desirable.
Can also be ordered separately
by installers who want to create
a non-standard system from
individual components.
I-Wave Steel Outdoor Enclosure
(PE40000), weatherproof, and with
plenty of room to add additional
sawitch mechanism if desirable.
Can also be ordered separately
by installers who want to create
a non-standard system from
individual components.
Three-Circuit Clock (P1353ME)
offers timer capability and can
control up to 3 pool/spa circuits.
Offers five pre-programmed
configuration modes.
Three-Circuit Clock (P1353ME)
offers timer capability and can
control up to 3 pool/spa circuits.
Offers five pre-programmed
configuration modes.
24-volt Valve Actuators (PE24VA)
provide reliable control of 2-way and
3-way diverter valves. (2 are included,
additional units can be ordered)
24-volt Valve Actuators (PE24VA)
provide reliable control of 2-way and
3-way diverter valves. (2 are included,
additional units can be ordered)