User Manual
21-3609E rev1.0 xL Regional Settings Guide 93
NOTE: *2: If disabling reader, 0=disable card permanently, 1=disable card but set it so that it can be re-enabled later
at an enabling station, 2= disable card permanently and trigger auxiliary output , 3= disable card enable re-
enroll and trigger auxiliary output, 4 to 7 = not used, same as 1 (room for future expansion)
R001È02, 05 Keypad Selections (left to right on keypad screen)
Name Selections Description Regional Settings Default
Reader Class Map
Schedule
00 = Treat as In Schedule
01 – 250 Schedule
Enter a schedule for reader-
class restriction.
000
Group Number 00 = none, 1 – 63, Reader
Group Number.
00
In Schedule A
9(yes) □ (no)
Whether Class A users can
enter during schedule
9(yes)
In Schedule B
9(yes) □ (no)
Whether Class B users can
enter during schedule
9(yes)
In Schedule C
9(yes) □ (no)
Whether Class C users can
enter during schedule
9(yes)
Out of Schedule A
9(yes) □ (no)
Whether Class A users can
enter outside of the sched.
9(yes)
Out of Schedule B
9(yes) □ (no)
Whether Class B users can
enter outside of the sched.
9(yes)
Out of Schedule C
9(yes) □ (no)
Whether Class C users can
enter outside of the sched.
9(yes)
Anti-pass Back
9(yes) □ (no)
Whether cards are to be
blocked against re-entry
before exiting first.
(no)
Log APB Violation
Only
9(yes) □ (no)
Whether 'Anti-pass Back
violators' will be granted
entry.
(no)
Enable Class
Checking
9(yes) □ (no)
Door class (A,B,C) checking,
on or off.
9(yes)
R001È03,06 Keypad Selections
(left to right on keypad screen) N America Example:
Name Selections Description Regional Settings Default
Card Mode Schedule 00 = Use as In Schedule
setting
01 – 250 (Schedule)
Enter a schedule to allow cycling
between different 'card' modes
during the daytime, vs. after-
hours.
000
Reader Mode
Schedule
00 = Use as In Schedule
setting
01 – 250 (Schedule)
Enter a schedule to allow cycling
between different reader modes
during the daytime, compared
with after-hours.
000
Card Mode In
Schedule
0=Card only,1= Card + PIN, 2=
Card or UID/ PIN,3= UID/ PIN
only
The basic method that entrants
will have to use to gain entry at
this door—i.e., via access token
and/or by keying-in a PIN.
2
Card Mode Out of
Schedule
0=Card only,1= Card + PIN, 2=
Card or UID/ PIN, 3 = UID/ PIN
only
Same as ‘Card Mode In
Schedule’
2
Reader Mode In
Schedule
0=Normal,1= Dual Custody, 2=
Escort, 3= Toggle Lock all user,
4= Toggle lock authorized. 5–
7=Future
Sets whether a second user, or
initial escort will be required to
gain entry (while the schedule is
active).
0
Reader Mode Out of
Schedule
0=Normal,1= Dual Custody, 2=
Escort, 3= Toggle Lock all user,
4= Toggle lock authorized. 5–
7=Future
Sets whether a second user, or
initial escort will be required to
gain entry (outside of the
schedule).
0
000 · 000 · 2 · 2 · 0 · 0·
ÈSave R001È03