VR4930WDM VT4930WDM VR4930WDM-R3 VT4930WDM-R3 VR4930WDM-6065 VT4930WDM-606 VR4930WDM-6065-R3 VT4930WDM-6065-R3 IFS Fiber Module Installation & Operation Instructions P/N 1062797 • REV B • ISS 01JUL11
RS - 232 DATA 7 6 5 4 3 2 1 RS - 422 / 4-WIRE RS-485 DATA 7 6 5 4 3 2 1 2-WIRE RS-485 DATA 7 6 5 4 3 2 1 DATA INPUT DATA OUT GROUND - DATA INPUT + DATA INPUT - DATA OUTPUT + DATA OUTPUT - DATA INPUT / OUTPUT + DATA INPUT / OUTPUT
Coax cable VT4930WDM FM VIDEO TRANSMITTER + DATA TRANSCEIVER DATA TRANSMIT FIBER OPTIC CABLE - DATA (IN) - 7 RS485 (RS422) + DATA (IN) - 6 RS232 IN GROUND - 5 RS232 OUT DATA RECEIVE ifs VIDEO IN RS232 OUT - 4 International Fiber Video Source RS422 Systems - DATA OUT - 3 + DATA OUT - 2 GROUND - 1 Incorporated ON = RS485 VIDEO IN POWER OFF = RS422 AC - 3 24 VAC CENTER TAPPED -2 AC - 1 Blue Green Brown Simplex single mode fiber optic cable VR4930WDM FM VIDEO RECEIVER + DATA TRANSCEIV
A B VT4930WDM C D A B C D Data Transmit Data Receive Video In Power LED illuminates NOTE: WITHOUT PROPER FIBER CONNECTION, LED's DO NOT INDICATE CORRECT OPERATIONAL STATUS OF THE UNIT.
FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesirable operation. Changes or modifications not expressly approved by International Fiber Systems, Inc. could void the user’s authority to operate the equipment.
Contacting us For help installing, operating, maintaining, and troubleshooting this product, refer to this document and any other documentation provided. If you still have questions, contact us during business hours (Monday through Friday, excluding holidays, between 5 a.m. and 5 p.m. Pacific Time). Sales and support contact information North America Toll-free: 855.286.8889 in the US, including Alaska and Hawaii; Puerto Rico; Canada. Outside the toll-free area: 503.885.5700.
Product Disassembly Instructions for WEEE Per European Directive 2002/95/EC Waste Electrical and Electronic Equipment Required Tools: One number 2 Phillips (crosstip) screwdriver. One number 2 flat screwdriver. For the enclosed box version: 1. Locate and remove box cover securement screws. Usually, but not limited to, at least 4 screws. 2. Lift off box top cover. 3. Locate and remove securement screws for printed circuit board. 4.
Copyright Trademarks and patents Manufacturer Certification ACMA compliance Canada European Union directives © 2011 UTC Fire & Security. All rights reserved. Interlogix and IFS names and logos are trademarks of UTC Fire & Security. Other trade names used in this document may be trademarks or registered trademarks of the manufacturers or vendors of the respective products. UTC Fire & Security Americas Corporation, Inc.
