User Manual
Table Of Contents
- Content
- Important safeguards
- Introduction
- Features
- Assembling the monitor
- Disassembling the monitor
- Attaching the monitor mount
- Connections
- Control panel
- Remote control (TVM-2702 / 3202 / 4002)
- Changing a monitor parameter
- Hot keys
- Adjustment procedure
- OSD functionality
- Self-diagnosis
- Troubleshooting
- Specifications
- Factory preset timings
Issue Solution
Image is
unstable
Check if the signal cable
is suitable to the video
card.
Image is not
centered, too
small, or too
large
Adjust Clock or H&V
Center to get the proper
image.
Picture
bounces or a
wave pattern
is present in
the picture
Keep the devices that
may cause electrical
interference away from
the monitor.
See the FCC
information in the front
of the manual.
Picture is
blurred
Adjust Contrast and
Brightness.
No sound Check the audio cables
are correctly connected
to the computer.
Adjust the volume after
checking the sound is
muted.
Check the audio system
in the computer.
Low sound Adjust the volume on
the OSD menu.
Adjust the volume of the
sound card in the
computer.
VIDEO screen
cannot be
seen
Check if PICTURE
mode has been set.
Check if the video
terminal is properly
connected.
Poor color in
the video
Adjust the Color or Tint
values on the OSD
Picture menu.
Grainy picture
in the video
Adjust the Sharpness
on the OSD Picture
menu.
TruVision Monitor User Manual 15