User Manual

TVE-400/800-1600 H.264 IP Video Encoder User Manual 27
If you select Manual Trigger, the signal remains active until it is manually
acknowledged by pressing the alarm button on the front panel or remote
control.
4. Select the recording schedules for the alarm output.
Click Edit. In the Edit Schedule Time window select the day of the week and
the time periods during the day when motion can be recorded. You can
schedule up to eight time periods in a day. Default is 24 hours.
Click Save to save the settings.
Note: The time periods defined cannot overlap.
5. Click Save to save settings.
Alarm input settings
The encoder can be configured to record when an alarm is triggered by an
external alarm device (for example, PIR detector, dry contacts…).
To configure alarm inputs:
1. Click Device Configuration > Alarm Settings > Alarm Input. The Alarm
Input window appears.
2. Select the alarm input number of a camera.
3. Select the alarm input type, NO or NC.
4. Set the arming schedule for the alarm input.
5. Select the response method to motion detection.
Click the Linking Method tab. Under Alarm Linking check one or more of
the desired the response methods:
- Audible warning: Trigger an audible beep when an alarm is detected
- Notify surveillance center: Send a notification or alarm signal to remote
alarm host when an event occurs. The alarm host refers to the computer
installed with remote client software