User Manual

TVE-DEC12 User Manual 33
Manage the decoding of a video tile
Right-click a stream tile to show the available commands for that tile. The list of options
displayed will depend on the device selected. The options available are:
• Stop decoding: Start/stop decoding.
• Show the decoding status: Show the decoding information for the selected
stream.
When you click More, a separate webpage will open and you can see the decoding
status of all streams.
• Turn on/off audio for the stream
• Decoding delay: Use this function to prioritize the quality or the fluency of the
stream. Select one of the options from the drop-down list:
• Enable Smart Information: with this function you can show the VCA information for
an IP camera in the stream.
Set up a sequence of streams in a tile
You can set up a sequence of streams on the monitor.
To set up a sequence:
1. Go to Video Wall.
2. Select a tile in the monitor (red rectangle will be seen around the tile).
3. Right-click the area name in the device tree and select Start Auto-Switch.
4. Setup the dwell time.
5. The sequence will start of all cameras of the area.
6. A small icon in the selected video tile on the webpage shows that the sequence is
running on the monitor.
It is a known limitation that the actual status of the sequence will not be displayed in the
webpage.