User Manual

28 TVE-DEC12 User Manual
Using the decoder
Once you have set up the devices/streams on the monitors (see “Configuring the video
wall” on page 22), you can then adjust where and how the video tiles appear on screen.
Add device streams in the monitors
You can easily add device streams to the monitors.
To add device streams to the monitors:
1. Go to Video Wall.
2. Drag and drop a device from the tree on to the desired monitor. By default, the
stream will be displayed in full screen mode.
Note: You cannot add more than three streams in full screen mode to one monitor.
If needed, resize the stream tile to be able to add more streams.
Note: Video images cannot be seen on the decoder window. Only the name of the
stream will appear.
3. Adjust the size of the stream tile as required. See the next section for instructions.
Adjust the size of a stream tile
When you click on a stream, the selected video tile is framed by a red rectangle. You
can change the size of the rectangle by pressing the left mouse button on the rectangle
and then dragging the mouse until the tile is the desired size (see Figure 6 on page 29).