Manual

TVE-DEC10 IP Video Decoder User Manual 23
2. Select an alarm output from the drop-down list.
3. Select a time out option from the Output Delay drop-down list.
The time out setting lets you define for how long a signal remains active after
the alarm has ended. Select a time out option: 5, 10, and 30 seconds, 1, 2, 5,
and 10 minutes, and Manual stop. If “Manual stop” is selected, the alarm
output will stop only when the alarm input is manually stopped.
4. Click Save to save settings.
Serial ports
Use this men u to configure the settings of the RS-232 and RS-485 ports.
To set up a serial port:
1. Click Configuration > Serial Port Parameters. The Serial Port Parameters
window appears.
2. Select the required serial port from the drop-down list: RS-232 or RS-485.
3. Enter the values for the following parameters:
RS-232 selected: Duplex mode, baud rate, data bit, parity type, and
operation mode.
RS-485 selected: Duplex mode, baud rate, data bit, stop bit, and parity type.
4. Click Save to save settings.
Arming time
You can set up to eight arming schedules for alarm inputs.
To set up the arming schedules:
1. Click Configuration > Arming time. The Arming Time window appears.