User Manual

TVE-120-420-820-1620 Encoder User Manual 51
You can schedule only one time period in a day. Default is 24 hours.
5. Select the response method to motion detection.
Click the Actions tab. Under Alarm Linking, check one of more of the desired
response method:
- Enable Alarm Audio: Record audio with the video.
- Notify Alarm Host: Send a notification or alarm signal to remote alarm host
when an event occurs. The alarm host refers to the computer installed with
remote client software
- Send Email to FTP: Send an email with alarm information to a user or users
when an event occurs.
Under Trigger Alarm Output select one of more alarm outputs to trigger an
external alarm when a motion detection event occurs. See “Alarm output settings”
below on how to set up an external alarm output.
Under Trigger Channel, select one or more channels to trigger recording when a
motion detection event occurs.
Select the PTZ control actions to link to the VCA event. Under PTZ Linking, select
the PTZ camera and enter the preset, preset tour, and/or a shadow tour to be
triggered when the alarm is detected. Select Enable to activate the option.
6. Under Copy to Camera, select the other cameras to which to copy this schedule.
7. Click Save to save settings.
Alarm output settings
You can connect the encoder to an alarm system, such as a siren or intrusion system,
which is then activated when an alarm is triggered. You can select how long the alarm
signal remains active as well as schedule when alarm outputs can be triggered.
The actual status of the alarm output is shown under Alarm Status. It is either ON or
OFF.
To configure an alarm output:
1. From the menu toolbar, click Configuration and then Remote Configuration >
Alarm & Event Setup > Alarm Output. The Alarm Output Settings window
appears.