User Manual

TVE-120-420-820-1620 Encoder User Manual 39
Option Description
3.
DHCP
DHCP (Dynamic Host Configuration Protocol) is a protocol for assigning
an IP address dynamically to a device each time it connects to a network.
Select this check box if you have a DHCP server running and want your
encoder to automatically obtain an IP address and other network settings
from that server. The DHCP server is typically available in your router.
Default value is Enabled.
4.
IPv4 Address
Enter the IP address for the encoder. This is the LAN IP address of the
encoder.
Default value is 192.168.1.82.
5.
IPv4 Subnet Mask
Enter the subnet mask for your network so the encoder will be recognized
within the network.
Default value is 255.255.255.0.
6.
IPv4 Default
Gateway
Enter the IP address of your network gateway so the encoder will be
recognized within the network. This is typically the IP address of your
router. Consult your router user manual or contact your ISP to get the
required information on your gateway.
Default value is 192.168.1.1.
7.
IPv6 Address
Enter the IPv6 address for the encoder.
Default value is fe80::240:30ff:fe48:2975/64.
8.
IPv6 Default
Gateway
Enter the IPv6 address of your network gateway so the encoder will be
recognized within the network. This is typically the IP address of your
router.
9.
MAC Address
Displays the MAC address. The MAC address is a unique identifier of your
encoder and it cannot be changed.
10.
MTU (Bytes)
Enter a value between 500 and 9676. Default is 1500.
11.
Preferred DNS
Server
Enter the preferred domain name server to use with the encoder. It must
match the DNS server information of your router. Check your router’s
browser interface or contact your ISP for the information.
12.
Alternate DNS
Server
Enter the alternate domain name server to use with the encoder.
13.
Enable Dynamic
Select the check box to set up a dynamic IP address.
Default value is Disabled.
14.
Register DNS
Name
Enter the registered DNS name. Request the DNS name from your ISP.
15.
Server Port
Use the server port for remote client software access. The port range is
between 1024 and 65535.
Enter the server port value. The default value is 8000.
16.
HTTP Port
The default value is 80.
17.
Multicast IP
Enter a D-class IP address between 224.0.0.0 to 239.255.255.255. Only
specify this option if you are using the multicast function. Some routers
prohibit the use of multicast function in case of a network storm.
18.
RTSP Service
Port
The RTSP (Real Time Streaming Protocol) is a network control protocol
designed for use in entertainment and communications systems to control
streaming media servers. The default value is 554.