User Manual

34 TVE-120-420-820-1620 Encoder User Manual
Click the Arming Schedule tab. Select the day of the week and the time periods
during the day when cross line can be detected. The configuration is the same as
that for motion detection (see “Motion detection” on page 22). You can schedule
only one time period in a day. Default is 24 hours. Click Save to save the settings.
Click Copy to copy these settings to other days of the week.
6. Select the response method to the VCA event.
Click the Actions tab. Under Alarm Linking, check one of more of the desired
response method:
- Enable Alarm Audio: Enable the buzzer.
- Notify Alarm Host: Send a notification or alarm signal to remote alarm host
when an event occurs. The alarm host refers to the computer installed with
remote client software
- Send Email: Send an email with alarm information to a user or users when an
event occurs.
Under Trigger Alarm Output select one of more alarm outputs to trigger an
external alarm when a motion detection event occurs. See “Alarm output settings”
on page 51 on how to set up an external alarm output.
Under Trigger Channel, select one or more channels to trigger recording when a
motion detection event occurs.
Select the PTZ control actions to link to the VCA event. Under PTZ Linking, select
the PTZ camera and enter the preset, preset tour, and/or a shadow tour to be
triggered when the alarm is detected. Select Enable to activate the option.
7. Click Save to save all the settings.
Intrusion detection
You can set up an area in the surveillance scene to detect when intrusion occurs. If
someone enters the area, a set of alarm actions can be triggered.
To setup intrusion detection actions:
1. From the menu toolbar, click Configuration and then Remote Configuration >
VCA > Sudden Scene Change. The Sudden Scene Change window appears.
2. Select a camera from the drop-down list.
3. Select Enable Intrusion Detection.
4. Select the area where you want intrusion detection to start.
Click the Area Settings tab. Select the region number to be drawn. Click Start
Draw and click on the camera image where you want the detection area to start.
When you draw the rectangle, all lines should connect end-to-end to each other. Up
to four regions are supported, each with a different time threshold and sensitivity.
Click Clear to clear the rectangles.
Note: The area can only be quadrilateral.