TruVision IR Bullet Camera TVB-2203 / TVB-4203 Installation Guide P/N 1072925 • REV A • ISS 10FEB15
Content Product overview 1 Camera description 3 Installation 4 Programming 8 Setup menu 9 Specifications 10 Regulatory information 11 Product overview This is the TruVision Bullet IR Camera Installation Guide for models TVB-2203/TVB-4203. This guide describes a standard installation.
Package contents: Camera with power and video output cables Template 4 M4 screws (4 x 25 mm) and 4 dry wall anchors (Ø7.5 x 24.
CD • WEEE and Battery Disposal Camera description 1. Video cable 4. Camera 2. Power cable 5. Sunshield 3. Bracket 6. Lens 7.
Installation To install the camera: 1. Using the template, place it level against the mounting surface and mark the position of the mounting holes. 2 Ceiling Mounting 1 1 2 2 1:Screw Hole for Bracket 2:Screw Hole for Mounting Base 1 1 2 2. Following all local codes, drill and prepare the mounting holes. 3. Install the back box on the wall (optional).
4. Route the cables to the cable hole and connect the corresponding cables. Connect a 75 ohm coaxial video cable to the video cable, and connect a 12 VDC power supply to the power cable. 5. Secure the camera to the ceiling or wall with the supplied screws.
6. Loosen the three camera screws and adjust the camera according to the figure below to get an optimum angle. Tighten the screws after completing the adjustments.
360° 90° 360° 7. Adjust the zoom screw and focus screw until you get the optimum surveillance angle. Focus Zoom OSD button 8. Use the OSD button to configure the camera parameters.
Programming The camera can be programmed using OSD menus. Once the camera hardware has been installed, you configure the camera by using a TVS-C200 controller (purchase separately). The Setup menu provides access to the camera configuration options. Please refer to the configuration manual for further information on setting up the camera. See page 9 for the setup menu. Program the camera by attaching a standard video monitor to the system. To access the Setup menu: 1.
Setup menu Installation Guide 9
Specifications Power supply 12 VDC Current Max. 420 mA Power consumption Max. 5 W Weight (net) 1350 g (1.97 lb.) Dimensions 105 x 95 x 265.4 mm (4.13 x 3.74 x 10.43 in.
Regulatory information Copyright: © 2015 United Technologies Corporation. Interlogix is part of UTC Building & Industrial Systems, a unit of United Technologies Corporation. All rights reserved. Trademarks and patents: Trade names used in this document may be trademarks or registered trademarks of the manufacturers or vendors of the respective products. Manufacturer: Interlogix 2955 Red Hill Avenue, Costa Mesa, CA 92626-5923, USA Authorized EU manufacturing representative: UTC Fire & Security B.V.
take adequate measures. Canada This Class A digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe A est conforme à la norme NMB-0330 du Canada. European Union directives: 12004/108/CE (EMC directive): Hereby, UTC Fire & Security declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2004/108/EC.
