User guide

ManualsBrandsInterlogix ManualsSafetySuperBus 2000 2X20

8 SuperBus 2000 2X20 LCD Alphanumeric Touchpad Installation Instructions

Specifications

Table 6: Touchpad/panel compatibility

Touchpad part no. Compatible panels

60-803-04 Concord, Concord Express

60-809-03 Custom Concord Versions

60-809-03-SEC Security Pro

UltraGard and Custom Versions

60-803-03 UltraGard and Custom Versions

60-803-01 Advent

Power requirements 12 VDC nominal, 120 mA maximum from

panel OR Auxiliary Power Supply.

Display 2-line, 40 character (2x20), backlit,

alphanumeric liquid crystal

Zone input One supervisable hardwire zone input

Data I/O 4-wire SuperBus 2000 auto addressing digital

data bus

Storage temperature -30° to 140°F (-34° to 60°C)

Operating temperature 32° to 140°F (0° to 60°C)

Humidity 90% relative, non-condensing

Dimensions 4.6” x 7.75 x 1.2” (H x W x D)

Chassis material High-Impact ABS plastic

Case color Belgian gray with gray imprints

Regulatory information

Manufacturer UTC Fire & Security Americas Corporation, Inc.

1275 Red Fox Rd., Arden Hills, MN 55112-6943,

USA

Listings UL 985 Household Fire Warning System Units

UL 1023 Household Burglar-Alarm System Units

UL1610 Central Station Burglar-Alarm Units

(Commercial Burglary)

CSFM California State Fire Marshall

Note: See specific panel Installation Instructions

for complete UL installation requirements for your

system.

Notices

FCC Part 15 Information to the User

Changes or modifications not expressly approved by UTC Fire

& Security can void the user’s authority to operate the

equipment.

FCC Part 15 Class A

his equipment has been tested and found to comply with the

limits for a class A digital device, pursuant to part 15 of the

FCC rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment is

operated in a commercial environment.

This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance

with the instruction manual, may cause harmful interference to

radio communications. Operation of this equipment in a

residential area is likely to cause harmful interference in which

case users will be required to correct the interference at their

own expense.

FCC Part 15 Class B

his equipment has been tested and found to comply with the

limits for a class B digital device, pursuant to part 15 of the

FCC rules. These limits are designed to provide reasonable

protection against interference in a residential environment.

This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance

with the instruction manual, may cause harmful interference to

radio communications. However, there is no guarantee that

interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the

equipment off an on, the user is encouraged to try to correct

the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and

receiver

• Connect the affected equipment and the panel receiver to

separate outlets, on different branch circuits

• Consult the dealer or an experienced radio/TV technician

for help

Contact information

www.utcfireandsecurity.com or www.interlogix.com

For customer support, see www.interlogix.com/customer-

support