Installation Manual

Page 6
Quik Bridge ® Two-Channel Receiver
receiver against the wall, mark the location of the
top-left and lower-right mounting holes.
4) Remove the base from the wall and install the
appropriate mounting hardware at the two loca-
tions you just marked.
5) Secure the receiver to the wall using two 1½'' Phil-
lips screws (included).
6) Secure the antenna to the wall using tape or sta-
ples.
Powering the Receiver
CAUTION: You must be free of all static elec-
tricity when handling sensors. Touch
a grounded metal object before han-
dling the circuit board.
You must connect the receiver to the 11 –15 VDC
power outputs on the panel, or to a separate power
supply (such as 12-volt DC adapter). To find the DC
power terminals on the panel, see the panel installa-
tion instructions.
To power the receiver:
1) Shut off or remove power from the panel.
2) Using Figur e5 as a guide, connect the receiver to
the panel or other equivalent power supply.
Figure 4. Connecting power to the receiver
9217G02A.DSF
SCREW MOUNTING HOLES
9217G04A.DSF
PANEL AUXILIARY
POWER TERMINALS
OR 11–15 VDC
POWER SUPPLY
RECEIVER POWER TERMINALS
+11–15 VDC
GROUND
+11–15 VDC GROUND
345678
12