Installation Manual

Page 5

Quik Bridge ® Two-Channel Receiver

Installation Guidelines

Observe the following guidelines when installing the

receiver:

■ Leave ten inches above the receiver for the

antenna.

■ Avoid areas that are likely to expose the receiver

to moisture.

■ Avoid areas with excessive metal or electrical wir-

ing, including furnace and utility rooms.

■ Avoid mounting the recevier on a metal surface.

When mounting on metal is unavoidable, mount

the receiver so that the antenna extends above the

metal surface (see Figur e2).

Figure 2. When mounting on metal is unavoidable

Installation

This section explains how to install the Quik Bridge

Two-Channel Receiver.

Mounting the Receiver

You can mount the receiver on a sheetrock wall, but

you may need to use additional mounting hardware.

CAUTION: You must be free of static electricity

before handling circuit boards.

Touch a bare metal surface or use a

grounding strap to discharge your-

self.

To mount the receiver on a wall:

1) Choose a location for the receiver.

Note: The Quik Bridge Two-Channel Receiver is a

super regenerative receiver. To ensure consis-

tent operation of the receiver, mount it at least

three feet away from other super regenerative

receivers (such as the receiver in most garage

door openers).

2) Remove the cover by pressing down on the center

of the top edge of the cover (see Figur e3).

Figure 3. Removing the cover

3) Hold the receiver against the wall at the desired

height and location, leaving at least ten inches

above the base for the antenna. While holding the

METAL

8836G02A.DSF

9217G07A.DSF