Installation Manual

8
PROGRAMMING THE LOCATIONS
Location 0 - Account Code (6 segments numerical data)
This account number is provided by AES. Enter the account code followed by a
“10" in the segment immediately after the last digit. If the account code is 6
digits long, program all 6 digits.
Location 1 - Partitions To Be Reported (1 segment feature selection data)
This location contains the partition(s) that should be included when reporting via
the AES radio. If you wish to exclude any partition from reporting, simply turn off
the LED corresponding to that particular partition. NOTE: If the partition LED
is off, NO event from that partition will report, regardless of what is
programmed in locations 3 through 6.
LED Partition LED Partition
1 1 5 5
2 2 6 6
3 3 7 7
4 4 8 8
Location 2 - Transmission Format (1 segment numerical data)
Location 2 contains the transmission format to be used.
Number Format
0 Contact ID
1 SIA
2 4+2
Locations 3 & 4 - Events That Can be Enabled When Phone Fault Is
Detected (8 segments feature selection data)
Locations 3 and 4 are used to select certain events to be sent via the AES radio
when a phone fault condition is detected. Turn the LED on for the corresponding
events to be reported. These events will only
be sent if the phone line is bad or
faulted. Refer to the programming worksheets on pages 9-13 for events.
Locations 5 & 6 - Events That Can Be Enabled When Phone Line Is Good
(8 segments of feature selection data)
Locations 5 and 6 are used to select certain events to be sent via the AES radio.
Turn the LED on for the corresponding events to be reported. These reports will
only be sent when the phone line is good. Note: If you want the reports sent
regardless of the phone line condition (good or faulted), you must
program locations 3 through 6.