Installation Manual

WIRE REQUIREMENTS

Table 2.1

Wire Gauge Length

(Feet)

Connected to NX8/NX8E Connected to NX-320

250 24 24

500 24 22

1000 22 20

2000 20 16

2500 18 16

PROGRAMMING THE NX582-E

USING THE LED KEYPAD

• Entering the Program Mode

To enter the Program Mode, press [r]-[8]. At this time, the five function

LEDs (Stay, Chime, Exit, Bypass, & Cancel) will begin to flash. Next, enter

the "Go To Program Code" (Factory Default is [9]-[7]-[1]-[3]). If the "Go To

Program Code" is valid, the "Service" LED will flash and the five function

LEDs will illuminate steady. You are now in the Program Mode and ready to

select the module to program.

# Select the Module to Program

All modules connected to the NX8/NX8E are programmed through the

keypad. Enter the address of the NX582-E, which is [7]-[7], followed by [#].

The Armed LED will illuminate while it is waiting for a programming location

to be entered. Other module entry numbers can be found in their

corresponding manuals.

# Programming a Location

Once the number of the module to be programmed has been entered, the

"Armed" LED will illuminate, indicating it is waiting for a programming

location to be entered. Any location can be accessed by directly entering the

desired programming location followed by the pound [#] key. If the location

entered is a valid location, the "Armed" LED will extinguish, the "Ready" LED

will illuminate and the binary data for the first segment of this location will be

shown by the zone LED's. While entering new data, the "Ready" LED will

begin flashing to indicate a data change in process. The flashing will

continue until the new data is stored by pressing the [r] key. Upon pressing

the [r] key, the keypad will advance to the next segment and display its