Installation Manual

4
WIRING THE INTERFACE
Wire the 3-position terminal on the NX582-E to the NX8/NX8E control panel
keypad interface as follows: Positive to KP POS, COM to KP COM, and DATA to
KP DATA. Connect the wiring harness from the NX582-E connector labeled J6 to
the AES radio connector labeled J1. Refer to connection diagram.
NX-582E LAYOUT
TERMINAL DESCRIPTION
Table 1.1
POS
Connect to the KP POS terminal of the NX8/NX8E. Current draw is
30 mA for the NX582-E.
COM
Connect to the KP COM terminal of the NX8/NX8E.
DATA
Connect to the KP DATA terminal of the NX8/NX8E.
J6
Connect to the cable of the AES radio.