Installation Manual

3
ADDRESSING
The NX582-E has a fixed address of 77. When programming the interface, enter
the Program Mode and select the device address as [7]-[7]. (See "Programming
the NX582-E", page 5.)
ENROLLING
The NX8/NX8E has the ability to automatically find and store in its memory the
presence of all keypads, zone expanders, wireless receivers, and any other
device on the keypad buss. This allows these devices to be supervised by the
control panel and illuminate the "Service" LED if one is not detected. To enroll
the devices, enter the Program Mode of the NX8/NX8E control panel using the
procedure outlined in the Installation Manual. When the Program Mode is exited,
the NX8/NX8E will automatically enroll the devices. The enrolling process takes
about 12 seconds, during which time the AService@ LED will illuminate. User
codes will not be accepted during the enrolling process. Once a module is
enrolled, if it is not detected by the control, the AService@ LED will illuminate.
UNDERSTANDING THE LIGHTS
The NX582-E has five (5) red LEDs along the front of the board. These LEDs
provide valuable information about the status of the NX582-E and the AES radio
as follows:
LED DESCRIPTION
DS1
Flashes each time the NX582-E has an opportunity to speak to the
control panel. It should be flashing about two times each second.
DS3
Flashes when it is attempting to establish communication with the
AES radio.
DS4
Flashes when the AES radio acknowledges receipt of the event
message.
DS5
Flashes when the NX582-E sends a test APing@ to the AES radio.
DS6
Flashes when the AES radio responds with a good reply to the test
APing@.
NOTE: DS3 through DS6 will be off if the system is initialized, normal and
waiting for a new event to report.
DS2
The sixth LED is located toward the back of the board. It is used for
hardware, and will only glow dimly when connected to the NX8/NX8E
control.