Installation Manual

2
GENERAL DESCRIPTION
The NX582-E is a microprocessor-controlled AES radio interface. This interface
allows any or all events from the NX8/NX8E control panel to be reported via the
AES radio Models 7050-E, 7050-DLR (v2.2 or higher), 7450, 7450-XL, 7750, and
7750-F.
ENCLOSURE INFORMATION
Inside the can, several 2-holed insertion points
have been constructed. This allows for either
vertical or horizontal placement of the modules.
Notice that the insertion points have two
sizes of holes -- a larger hole and a smaller
hole.
Diagram 1
: The black plastic PCB guides are
grooved on one edge where the PC Board will be
seated. The end with the half-moon protrusion
fits into the larger hole. The smaller hole is for
the screw.
Diagram 2
: Place the first black plastic PCB
guide in the top insertion point, grooved edge
downward. The half-moon protrusion will be in
the large hole. It does not require force. Insert
one of the provided screws into the smaller hole
(from inside the can) to secure it in place. A
screwdriver should reach through the notch that
runs the length of the guide to tighten the
screw. The second PCB guide should be
positioned opposite of the first (grooved edge
up) and placed in the lower insertion point,
using the same procedures described above.
Once mounted, screw it in securely.
Diagram 3
: The PC board should slide freely in
the grooves of both guides.