User guide

V. PROGRAMMING
A. USING THE LED KEYPAD
NOTE: The NX-108E / NX-116E / NX-124E series keypads should not be used to program user cards.
ACTION
RESULT
ENTERING THE PROGRAM MODE
  
       
Enters the Program Mode.
Stay, Chime, Exit, Bypass & Cancel LEDS will flash.
 [Go To Program Code]
Factory Default is 
       
If the "Go To Program Code" is valid, the "Service" LED will flash and
the 5 function LEDs will illuminate steady. You are now in the
Program Mode and ready to select the module address.
ENTERING THE MODULE ADDRESS
Scan a card.        The card reader will address itself.
  #
(example only)
       
Enters the module address. Refer to Table IV-1 on page 3 for the
address assigned by
the card reader module itself.
The Armed LED will illuminate while it is waiting for a programming
location to be entered.
PROGRAMMING A LOCATION
 If an attempt is made to program an invalid entry for a particular segment, the keypad sounder will emit
a triple error beep (beep, beep, beep), and remain in that segment awaiting a valid entry.
To Enter a Location:
 [location] #
       
The Armed LED will flash. If the location is valid, the "Armed" LED
will extinguish, the "Ready" LED will illuminate, and the zone LED’s
will show the data for the first segment of this location.
To Change Location Data:
 [changed data]
       
The "Ready" LED will flash to indicate a data change in process and
will continue until the data is saved.
 
       
The new data is saved.
The keypad will increment and display the next segment’s data.
NOTE: Repeat these steps until the last segment is
reached.
To Exit a Location:
 #
       
Exits from this location. The “Ready” LED will extinguish. The
"Armed" LED will illuminate waiting for a new programming location to
be entered.
To Review The Data:
 [location] #
       
The Armed LED will flash. If the location is valid, the "Armed" LED
will extinguish, the "Ready" LED will illuminate, and the zone LED’s
will show the data for the first segment of this location.
 
       
(Do not enter data.)
The next segment is displayed. Each time  is pressed, the data of
the next segment will be displayed for review.
Shortcuts:

Previous location.

Same location.

Next sequential location.
4
NX-1700E Card Reader