User Manual User guide
Table Of Contents
- Chapter 1 TVN 20 System Basics
- Chapter 2 TVN Advanced Topics
- HDD Configuration & Management
- Account Management (Users)
- Advanced Camera Settings
- Exception Parameters – System Health Monitoring
- Video Loss
- Remote Record & Video Download
- Additional Network Settings
- Remote Update
- Serial Port Settings – RS-232 & RS-485
- Log Files
- Appendix A Troubleshooting
- Appendix B TVN 20 Specifications
- Appendix C TVN 20 IP Camera Capacities
- Appendix D TVN 20 Supported IP Cameras
- Appendix E TVN 20 USB Archive Options
- Appendix F TruVision Device Finder
- Appendix GGlossary of Terms
- Appendix HWarranty and Support

TruVision NVR 20 User Manual 63
Account Management (Users)
Introduction
The Browser supports three types of Users on the system. One administrative
User with full rights to the entire system and two additional levels of Users with
specific rights to camera and system features. The two additional user
categories are:
• Guest
• Operator
These two user groups have a default set of capabilities; however, these can be
modified to fit your needs. These capabilities will apply to all users you assign to
these user groups. There is only one (1) admin user assigned to a system.
The default Admin login is:
User Name: admin
Password: 1234
Caution: You can change the default admin user’s password. However, if you
are using TruVision Navigator software, the device login user and password is
the admin account defined on the TVN 20. If you change the default password
on the TVN 20, you must make sure TruVision Navigator also uses the same
password.
Account Management is found under CONFIG>Remote Config>Configuration
parameters>Account Management.