User Manual User guide
Table Of Contents
- Chapter 1 TVN 20 System Basics
- Chapter 2 TVN Advanced Topics
- HDD Configuration & Management
- Account Management (Users)
- Advanced Camera Settings
- Exception Parameters – System Health Monitoring
- Video Loss
- Remote Record & Video Download
- Additional Network Settings
- Remote Update
- Serial Port Settings – RS-232 & RS-485
- Log Files
- Appendix A Troubleshooting
- Appendix B TVN 20 Specifications
- Appendix C TVN 20 IP Camera Capacities
- Appendix D TVN 20 Supported IP Cameras
- Appendix E TVN 20 USB Archive Options
- Appendix F TruVision Device Finder
- Appendix GGlossary of Terms
- Appendix HWarranty and Support
10 TruVision NVR 20 User Manual
Figure 4: Initial connection page
Alternatively, using Interlogix’s TruVision Navigator video management software
the user can view and respond to events from multiple TVN 20s or a mixture of
Interlogix TruVision DVRs and NVRs.
Note: PTZ and Brightness/Contrast controls are only available on specific
TruVision models of IP cameras.
Initial Config Tab Window
From this page you can quickly add IP cameras, configure recording schedules,
enable motion only recording modes as well as define the behavior of various
alarm inputs and outputs on the box. Additionally the browser allows
customization of system events affecting hard drive status, video loss, and more.
Configuration on the TVN 20 is optimized for quick connection to Interlogix’s
TruVision Navigator video management software.
There are two main configuration elements:
Remote Config – is the primary area where all IP camera functions are
scheduled and managed.
Local Config – this controls how users who only use the TVN 20 browser for
system operation may define where snapshots, video download and local
recording on the Browser’s PC are managed.