User Manual
Table Of Contents
- Preface
- Chapter 1 KTD-405/405A/405-2D overview
- Chapter 2 Installation
- Chapter 3 Programming
- Programming modes
- Supervisor programming
- Figure 17. Supervisor programming menu tree
- Figure 18. KB3 PTZ PROTOCOL display
- Figure 19. ENTER REMOTE PRGMG display
- Figure 20. KEYPAD TITLE display
- Figure 21. KEYPAD LOCKOUT PRIORITY displays
- Figure 22. Lowest user programmed preset menu
- Figure 23. PROGRAM SOFT KEYS display
- Figure 24. PRESS KEY TO PROGRAM display
- Figure 25. Command selection display
- Figure 26. Confirm command selection display
- Figure 27. CHANGE ACCESS CODES displays
- Figure 28. BAUD RATE display
- Figure 29. SYSTEM CONTROL display
- Figure 30. INACTIVE TIMEOUT display
- User programming
- Figure 31. OPERATING MODE menu
- Standard Digiplex menus
- Zone menus
- Figure 38. OPERATING MODE menu
- Figure 39. Zone menu
- Figure 40. ENTER ZONE ADDRESS menu
- Figure 41. ZONE xx TITLE menu
- Figure 42. SEND TO ALL KEYPADS display
- Figure 43. Zone hub display
- Figure 44. Zone monitor outputs
- Figure 45. Zone camera inputs
- Figure 46. Access restriction menus
- Figure 47. ZONE xx ACCESS menu
- Figure 48. Annunciation menu
- Figure 49. Call tone menu
- Figure 50. SPOT MONITOR NUMBER menu
- Remote programming
- Chapter 4 Operation
- Operating your keypad
- Standard Digiplex mode
- Figure 55. Normal operating display
- Selecting a monitor
- Selecting a camera
- Controlling a camera
- Setting a preset
- Recalling a preset
- Operating group switching on Digiplex IV switchers
- Setting autopan limits
- Controlling a DVMRe/multiplexer (hybrid mode)
- Controlling a recording device
- System information menus
- Help menu
- Audio
- Zone mode
- Chapter 5 Troubleshooting and support
- Appendix A Sample configurations and charts
- Sample analog system configurations
- Sample IP system configuration
- Receiver site addressing
- Reprogrammable keys and commands
- System planning chart
- Index
Appendix A
Sample configurations and charts
67
Reprogrammable keys and commands
From the supervisor programming mode you can reprogram any of the soft keys with any of the available
commands.
Note: Holding the seq key for three seconds returns you to the normal operating display, except on displays where esc is
required to exit.
To reprogram soft keys, do the following:
Figure 75. Keys that can be reprogrammed
1. Beginning at the normal operating display,
enter the supervisor programming mode by
pressing and holding the key.
Figure 72. Normal operating display
2. After the keypad beeps and the code entry
display appears (Figure 73), quickly enter
the access code for the supervisor menus by
pressing the 1-4-7-6-seq key sequence.
The display will automatically advance to
the next display.
Figure 73. Code entry display
3. Press the key (for NEXT) until the
PROGRAM SOFT KEYS display appears
(Figure 74). Press the + side of the zoom,
focus, or iris key.
Note: Use the plus side of any of these keys for YES and
the minus side of any of these keys for NO.
Figure 74. PROGRAM SOFT KEYS display
CAMERA 0
MONITOR 1
ENTER PROGRAMMING
CODE:
PROGRAM SOFT KEYS?
_
C
AMERA 22
Z
ONE 32 P
A
Recommended set
Complete set