User Manual
Table Of Contents
- Preface
- Chapter 1 KTD-405/405A/405-2D overview
- Chapter 2 Installation
- Chapter 3 Programming
- Programming modes
- Supervisor programming
- Figure 17. Supervisor programming menu tree
- Figure 18. KB3 PTZ PROTOCOL display
- Figure 19. ENTER REMOTE PRGMG display
- Figure 20. KEYPAD TITLE display
- Figure 21. KEYPAD LOCKOUT PRIORITY displays
- Figure 22. Lowest user programmed preset menu
- Figure 23. PROGRAM SOFT KEYS display
- Figure 24. PRESS KEY TO PROGRAM display
- Figure 25. Command selection display
- Figure 26. Confirm command selection display
- Figure 27. CHANGE ACCESS CODES displays
- Figure 28. BAUD RATE display
- Figure 29. SYSTEM CONTROL display
- Figure 30. INACTIVE TIMEOUT display
- User programming
- Figure 31. OPERATING MODE menu
- Standard Digiplex menus
- Zone menus
- Figure 38. OPERATING MODE menu
- Figure 39. Zone menu
- Figure 40. ENTER ZONE ADDRESS menu
- Figure 41. ZONE xx TITLE menu
- Figure 42. SEND TO ALL KEYPADS display
- Figure 43. Zone hub display
- Figure 44. Zone monitor outputs
- Figure 45. Zone camera inputs
- Figure 46. Access restriction menus
- Figure 47. ZONE xx ACCESS menu
- Figure 48. Annunciation menu
- Figure 49. Call tone menu
- Figure 50. SPOT MONITOR NUMBER menu
- Remote programming
- Chapter 4 Operation
- Operating your keypad
- Standard Digiplex mode
- Figure 55. Normal operating display
- Selecting a monitor
- Selecting a camera
- Controlling a camera
- Setting a preset
- Recalling a preset
- Operating group switching on Digiplex IV switchers
- Setting autopan limits
- Controlling a DVMRe/multiplexer (hybrid mode)
- Controlling a recording device
- System information menus
- Help menu
- Audio
- Zone mode
- Chapter 5 Troubleshooting and support
- Appendix A Sample configurations and charts
- Sample analog system configurations
- Sample IP system configuration
- Receiver site addressing
- Reprogrammable keys and commands
- System planning chart
- Index
KTD-405/KTD-405A/KTD-405-2D Controller Keypad
User Manual
46
System information menus
In standard Digiplex mode, holding mon at the normal operating menu displays three system information
menus. These menus show the keypad’s address, version, and system size setting. Use and to navigate
through these menus. To exit the system information menus, press from the first menu or press esc.
Figure 58. Maximum values
Help menu
The HELP menu lets you determine the function associated with each key.
To display the HELP menu (Figure 59), at the normal operating display, press and hold the esc key, then press
the mon key. Release both keys.
Figure 59. HELP menu
To display a key’s default function, at the HELP menu, press the key. To display a key’s shifted (secondary)
function, press esc and the key. (See Table 3 on page 38 for a list of keys and their default assignments for
normal and shifted functions.)
The help menu times out in ten seconds. To force an exit, press .
Highest preset
Lowest user-programmable preset (quick set)
Maximum number of cameras
Maximum number of monitors
Maximum number of recorders
Maximum number of multiplexers
Monitor offset
Annunciation and tone
CAM MN MX RC PS
QS MO AT
Numbers shown are for system controllers; for Digiplexes, the camera maximum is 1023 and the monitor maximum is 128.
HELP MODE:
ENTER=EXIT