User Manual

KTD-405/KTD-405A/KTD-405-2D Controller Keypad
User Manual
38
Operating your keypad
Table 3 shows the default functions for the keypad’s keys in normal and shifted mode (shaded cells). To select
the shifted mode, press and hold esc and then press the key. Some keys can be changed to other functions.
Reprogrammable keys and commands on page 67 in Appendix A shows which keys can be reassigned. Use the
help function (shifted mon key) to find the current function assigned to any key.
Table 3. Normal and shifted key functions
Key Function
mon With number keys, selects active monitor from matrix switcher or multiplexer.
Help
view Works in two ways, depending on the type of multiplexer or DVMRe you are addressing: for duplex DVMRes and
most multiplexers, pressing view steps selected monitor through programmed multiscreen views. Triplex
DVMRes and some brands of multiplexers, pressing view with number keys selects multiscreen views (view, 2
calls up 2 x 2 view, and view, 4 calls up 4 x 4 view) If view is pressed and held for 5 seconds, the keypad will
broadcast a command to all PTZ’s to display their site address and zone mode; Caliber devices will display their
address; status disappears when the key is released.
View message. Recalls the last message sent from HDS system controller.
zone With number keys, selects a zone.
Group. Activates group switching and group sequence initiation.
aux 1 Open gate (or other device) at selected camera address. *
Unlock *
aux 2 Close *
Lock *
aux 3 Stop *
Flip. Pan 180 degrees to point in opposite direction.
aux 4 Last. Switches back to the camera selected just before the current one. For KTD-405A this is a talk function.
Stabilize. Turns on the image stabilization function of the camera if preset.
seq Activates a sequence tour on the active monitor.
Function
alarm Toggles active monitor between the alarm on and alarm off modes; calls up help menus when remotely
programming matrix switcher and CyberDome.
Lens reset. Sends a command to the camera module to reset the lens controller.
tour With number keys 1 – 64, places PTZ camera in tour mode; or, if pressed and held for 3 sec, keypad beeps and
sends an autopan command to PTZ camera. With number keys 1-16 Tours, unit limited. (IE CyberDome 2
supports 8, 4 Shadow Tours, 4 Preset Tours)
Shadow. Starts programming Showdow Tour 1.