User Manual
Table Of Contents
- Preface
- Chapter 1 KTD-405/405A/405-2D overview
- Chapter 2 Installation
- Chapter 3 Programming
- Programming modes
- Supervisor programming
- Figure 17. Supervisor programming menu tree
- Figure 18. KB3 PTZ PROTOCOL display
- Figure 19. ENTER REMOTE PRGMG display
- Figure 20. KEYPAD TITLE display
- Figure 21. KEYPAD LOCKOUT PRIORITY displays
- Figure 22. Lowest user programmed preset menu
- Figure 23. PROGRAM SOFT KEYS display
- Figure 24. PRESS KEY TO PROGRAM display
- Figure 25. Command selection display
- Figure 26. Confirm command selection display
- Figure 27. CHANGE ACCESS CODES displays
- Figure 28. BAUD RATE display
- Figure 29. SYSTEM CONTROL display
- Figure 30. INACTIVE TIMEOUT display
- User programming
- Figure 31. OPERATING MODE menu
- Standard Digiplex menus
- Zone menus
- Figure 38. OPERATING MODE menu
- Figure 39. Zone menu
- Figure 40. ENTER ZONE ADDRESS menu
- Figure 41. ZONE xx TITLE menu
- Figure 42. SEND TO ALL KEYPADS display
- Figure 43. Zone hub display
- Figure 44. Zone monitor outputs
- Figure 45. Zone camera inputs
- Figure 46. Access restriction menus
- Figure 47. ZONE xx ACCESS menu
- Figure 48. Annunciation menu
- Figure 49. Call tone menu
- Figure 50. SPOT MONITOR NUMBER menu
- Remote programming
- Chapter 4 Operation
- Operating your keypad
- Standard Digiplex mode
- Figure 55. Normal operating display
- Selecting a monitor
- Selecting a camera
- Controlling a camera
- Setting a preset
- Recalling a preset
- Operating group switching on Digiplex IV switchers
- Setting autopan limits
- Controlling a DVMRe/multiplexer (hybrid mode)
- Controlling a recording device
- System information menus
- Help menu
- Audio
- Zone mode
- Chapter 5 Troubleshooting and support
- Appendix A Sample configurations and charts
- Sample analog system configurations
- Sample IP system configuration
- Receiver site addressing
- Reprogrammable keys and commands
- System planning chart
- Index
Chapter 3
Programming
35
Quick Shadow Tour 1 programming short cut
This section explains how to use the shadow tour 1 programming shortcut.
To program a ShadowTour™, do the following:
4. Begin the manual operation sequence you want to record as your ShadowTour.
5. At the END SHADOW TOUR PROGRAMMING display, press the esc key to stop recording the
shadow tour.
Note: The keypad is still recording your manual operation even though the END SHADOW TOUR PROGRAMMING display
returns to the normal operating display after a few seconds. Continue your sequence and press esc to stop recording
Your shadow tour is now available for use. Follow the keypad’s instructions for activating the shadow tour. See
Table 3 on page 38.
Note: The zoom, focus, and iris buttons do not work while programming a shadow tour using the short cut method. 405-2D
users should not use this feature because the Zoom keys are disabled.
1. Beginning at the normal operating display,
bring up the PROGRAM SHADOW TOUR
display (Figure 52) by pressing and holding
the esc key, then pressing the tour key.
Figure 52. Normal operating display
2. At the PROGRAM SHADOW TOUR display
(Figure 53), press the + side of the zoom,
focus, or iris key to start recording a shadow
tour.
Figure 53. PROGRAM SHADOW TOUR display
3. Quickly move to the next step after the
keypad beeps and the END SHADOW TOUR
PROGRAMMING display appears
(Figure 54).
Figure 54. END SHADOW TOUR PROGRAMMING display
CAMERA 0
MONITOR 1
PROGRAM SHADOW
TOUR? _
PRESS <ESC> TO END
SHADOW TOUR