User Manual
Table Of Contents
- Preface
- Chapter 1 KTD-405/405A/405-2D overview
- Chapter 2 Installation
- Chapter 3 Programming
- Programming modes
- Supervisor programming
- Figure 17. Supervisor programming menu tree
- Figure 18. KB3 PTZ PROTOCOL display
- Figure 19. ENTER REMOTE PRGMG display
- Figure 20. KEYPAD TITLE display
- Figure 21. KEYPAD LOCKOUT PRIORITY displays
- Figure 22. Lowest user programmed preset menu
- Figure 23. PROGRAM SOFT KEYS display
- Figure 24. PRESS KEY TO PROGRAM display
- Figure 25. Command selection display
- Figure 26. Confirm command selection display
- Figure 27. CHANGE ACCESS CODES displays
- Figure 28. BAUD RATE display
- Figure 29. SYSTEM CONTROL display
- Figure 30. INACTIVE TIMEOUT display
- User programming
- Figure 31. OPERATING MODE menu
- Standard Digiplex menus
- Zone menus
- Figure 38. OPERATING MODE menu
- Figure 39. Zone menu
- Figure 40. ENTER ZONE ADDRESS menu
- Figure 41. ZONE xx TITLE menu
- Figure 42. SEND TO ALL KEYPADS display
- Figure 43. Zone hub display
- Figure 44. Zone monitor outputs
- Figure 45. Zone camera inputs
- Figure 46. Access restriction menus
- Figure 47. ZONE xx ACCESS menu
- Figure 48. Annunciation menu
- Figure 49. Call tone menu
- Figure 50. SPOT MONITOR NUMBER menu
- Remote programming
- Chapter 4 Operation
- Operating your keypad
- Standard Digiplex mode
- Figure 55. Normal operating display
- Selecting a monitor
- Selecting a camera
- Controlling a camera
- Setting a preset
- Recalling a preset
- Operating group switching on Digiplex IV switchers
- Setting autopan limits
- Controlling a DVMRe/multiplexer (hybrid mode)
- Controlling a recording device
- System information menus
- Help menu
- Audio
- Zone mode
- Chapter 5 Troubleshooting and support
- Appendix A Sample configurations and charts
- Sample analog system configurations
- Sample IP system configuration
- Receiver site addressing
- Reprogrammable keys and commands
- System planning chart
- Index
KTD-405/KTD-405A/KTD-405-2D Controller Keypad
User Manual
34
Remote programming
At the ENTER PROGRAMMING CODE menu, press 9-5-1-seq to display the REMOTE PROGRAMMING
menu, which allows you to program devices such as cameras and VCRs, as shown in the tree in Figure 51.
Figure 51. Remote programming menu tree
A few things to note about your choices within this menu tree:
• You must select the zone before entering programming mode.
• Pressing 3 in standard Digiplex mode prompts you to enter a camera site number.
• Pressing 3 in zone mode prompts you to enter a camera number in the current zone:
Note: Supervisors may disable remote programming.
ENTER MONITOR
NUMBER:
SEE MONITOR FOR
MENUS
1=SWITCHER/MPLX
2=ALARMS
3-CAMERA
ENTER CALIBUR
ADDRESS:
ENTER MONITOR
NUMBER:
SEE MONITOR FOR
MENUS
SEE MONITOR FOR
MENUS
1=440 2=CALIBUR
3=340/348BACK
SEE MONITOR FOR
MENUS
SEE MONITOR FOR
MENUS
ENTER CAMERA SITE
NUMBER___BACK
Standard Digiplex mode
Zone mode
SEE MONITOR FOR
MENUS
ENTER ZONE XCAMERA
NUMBER__BACK