User Manual

KTD-405/KTD-405A/KTD-405-2D Controller Keypad
User Manual
28
User programming
As explained in Entering programming modes on page 21, to enter the user menus, from the ENTER
PROGRAMMING CODE menu, press 5-7-9-seq. This brings up the OPERATING MODE menu
(Figure 31).
Figure 31. OPERATING MODE menu
The operating mode defines the keypad’s system architecture. The choices are DIGIPLEX, which is
conventional system operation (see Standard Digiplex menus on page 28), and ZONE, which divides the
system into 32 zones (see Zone menus on page 31).
Standard Digiplex menus
The next five menus are used to set the system’s size to restrict the user from calling up unused addresses. They
also define the maximum number of keystrokes used to automatically select an address. For example, if there
are fewer than ten cameras in the system, the keypad user can select each camera site with only one key press.
1. Enter the highest camera number in your
system.
2. Enter the highest monitor number in your
system.
3. Enter the highest multiplexer number in your
system.
4. Enter the highest VCR number in your
system
5. Enter the highest preset number.
Figure 32. Maximum settings
OPERATING MODE:
DIGIPLEX
SYSTEM SIZE:
(CAMERAS) 7999
SYSTEM SIZE:
(MONITORS) 255
SYSTEM SIZE:
(DSR/VCR) 32
SYSTEM SIZE:
(PRESETS) 63
SYSTEM SIZE:
(MPLXS) 32