User Manual
Table Of Contents
- Preface
- Chapter 1 KTD-405/405A/405-2D overview
- Chapter 2 Installation
- Chapter 3 Programming
- Programming modes
- Supervisor programming
- Figure 17. Supervisor programming menu tree
- Figure 18. KB3 PTZ PROTOCOL display
- Figure 19. ENTER REMOTE PRGMG display
- Figure 20. KEYPAD TITLE display
- Figure 21. KEYPAD LOCKOUT PRIORITY displays
- Figure 22. Lowest user programmed preset menu
- Figure 23. PROGRAM SOFT KEYS display
- Figure 24. PRESS KEY TO PROGRAM display
- Figure 25. Command selection display
- Figure 26. Confirm command selection display
- Figure 27. CHANGE ACCESS CODES displays
- Figure 28. BAUD RATE display
- Figure 29. SYSTEM CONTROL display
- Figure 30. INACTIVE TIMEOUT display
- User programming
- Figure 31. OPERATING MODE menu
- Standard Digiplex menus
- Zone menus
- Figure 38. OPERATING MODE menu
- Figure 39. Zone menu
- Figure 40. ENTER ZONE ADDRESS menu
- Figure 41. ZONE xx TITLE menu
- Figure 42. SEND TO ALL KEYPADS display
- Figure 43. Zone hub display
- Figure 44. Zone monitor outputs
- Figure 45. Zone camera inputs
- Figure 46. Access restriction menus
- Figure 47. ZONE xx ACCESS menu
- Figure 48. Annunciation menu
- Figure 49. Call tone menu
- Figure 50. SPOT MONITOR NUMBER menu
- Remote programming
- Chapter 4 Operation
- Operating your keypad
- Standard Digiplex mode
- Figure 55. Normal operating display
- Selecting a monitor
- Selecting a camera
- Controlling a camera
- Setting a preset
- Recalling a preset
- Operating group switching on Digiplex IV switchers
- Setting autopan limits
- Controlling a DVMRe/multiplexer (hybrid mode)
- Controlling a recording device
- System information menus
- Help menu
- Audio
- Zone mode
- Chapter 5 Troubleshooting and support
- Appendix A Sample configurations and charts
- Sample analog system configurations
- Sample IP system configuration
- Receiver site addressing
- Reprogrammable keys and commands
- System planning chart
- Index
Chapter 3
Programming
21
Entering programming modes
To enter programming mode, do the following:
3. Enter your programming code:
• Supervisor: Press 1-4-7-6-seq and see Supervisor programming on page 22.
• User: Press 5-7-9-seq and see User programming on page 28.
• Remote device: Press 9-5-1-seq and see Remote programming on page 34.
Note: These access codes can be changed by the installer or administrator. They will tell you the new codes if your are allowed
access to the menu. Menus time out after four minutes. Menus that were not implemented in this release are indicated by
two beeps and a message that reads NOT IMPLEMENTED.
1. When you provide power to the unit, the
normal operating display appears
(Figure 15).
Figure 15. Normal operating display
2. Press and hold the key until you hear a
tone and see the ENTER PROGRAMMING
CODE menu appears (Figure 16).
Note: The ENTER PROGRAMMING CODE menu times out
after five seconds.
Figure 16. ENTER PROGRAMMING CODE menu
CAMERA 0
MONITOR 1
ENTER PROGRAMMING
CODE: