User Manual
Table Of Contents
- Preface
- Chapter 1 KTD-405/405A/405-2D overview
- Chapter 2 Installation
- Chapter 3 Programming
- Programming modes
- Supervisor programming
- Figure 17. Supervisor programming menu tree
- Figure 18. KB3 PTZ PROTOCOL display
- Figure 19. ENTER REMOTE PRGMG display
- Figure 20. KEYPAD TITLE display
- Figure 21. KEYPAD LOCKOUT PRIORITY displays
- Figure 22. Lowest user programmed preset menu
- Figure 23. PROGRAM SOFT KEYS display
- Figure 24. PRESS KEY TO PROGRAM display
- Figure 25. Command selection display
- Figure 26. Confirm command selection display
- Figure 27. CHANGE ACCESS CODES displays
- Figure 28. BAUD RATE display
- Figure 29. SYSTEM CONTROL display
- Figure 30. INACTIVE TIMEOUT display
- User programming
- Figure 31. OPERATING MODE menu
- Standard Digiplex menus
- Zone menus
- Figure 38. OPERATING MODE menu
- Figure 39. Zone menu
- Figure 40. ENTER ZONE ADDRESS menu
- Figure 41. ZONE xx TITLE menu
- Figure 42. SEND TO ALL KEYPADS display
- Figure 43. Zone hub display
- Figure 44. Zone monitor outputs
- Figure 45. Zone camera inputs
- Figure 46. Access restriction menus
- Figure 47. ZONE xx ACCESS menu
- Figure 48. Annunciation menu
- Figure 49. Call tone menu
- Figure 50. SPOT MONITOR NUMBER menu
- Remote programming
- Chapter 4 Operation
- Operating your keypad
- Standard Digiplex mode
- Figure 55. Normal operating display
- Selecting a monitor
- Selecting a camera
- Controlling a camera
- Setting a preset
- Recalling a preset
- Operating group switching on Digiplex IV switchers
- Setting autopan limits
- Controlling a DVMRe/multiplexer (hybrid mode)
- Controlling a recording device
- System information menus
- Help menu
- Audio
- Zone mode
- Chapter 5 Troubleshooting and support
- Appendix A Sample configurations and charts
- Sample analog system configurations
- Sample IP system configuration
- Receiver site addressing
- Reprogrammable keys and commands
- System planning chart
- Index
Chapter 2
Installation
13
Twisted-pair connections
The twisted-pair connections are available to connect additional devices or for existing installations where
individual wires were used to connect to the old phone-style I/O box. Easy-to-use RJ-cable connections are
also available on the new I/O box. See RJ-cable connections on page 12.
Adhere to all installation guidelines while making connections, including your local codes and those provided
in Installation guidelines on page 8.
Figure 8. Wire connections to the I/O box
Bias switch
The bias switch maintains an appropriate load on the RS-485 line. Set the bias switch to ON for one
keypad in a typical system (any one keypad and only one keypad). If your system is divided into
groups that are separated by fiber or Ethernet bridges, you must set the bias switch to ON for one
keypad in each group.
Tie-wrap
For safety, use a tie-wrap
to secure the power cable
to the tie-in.
Observe polarity for:
•12VDC
•RS-422
•RS-485
Earth ground (to ground)
RS-422 IN (from keypad or
alarm unit, if used)
Speaker/shield (to remote
speaker, if used)
* For mux, DVMRe, or additional keypad I/O box. (RS-485
connections are also available with the RJ45 connectors.)
RS-485 connection*
RS-422 OUT (to switcher
or cameras)
12 VDC power
(12 VDC transformer must
have a positive center
polarity plug
)