DED2500-E DED2500-M DED2500-EM DED2500-S DED2500-ES IFS Fiber Module Installation & Operation Instructions P/N 1062839 • REV B • ISS 01MAR12
DED2500 series C A D E Left Side B F H G Right Side J A B C D E F G H J Network Connection (Electrical) Network Connection (Optical) Network Activity (Optical) Blinks with data transfer Link OFF: No Link Network Activity (Electrical) Blinks with data transfer Link Speed (Electrical) OFF: 10 Mbps Power LED illuminates Power Connector Data Connector ON: Link ON: 100 Mbps
DED2500 series DED2500-EM SERIAL TO ETHERNET MEDIA CONVERTER - 10 NO - 9 CONTACT CLOSURE 10 /100 TX COM- 8 NC - 7 2W RS485 (-) - 6 2W RS485 (+) - 5 RS485 OUT (-) - 4 LNK ACT RS485 OUT (+) RS232 OUT - 3 ifs TX B 100FX RX RS485 IN (-) - 2 In te rn a ti o n a l RS485 IN (+) RS232 IN -1 Fiber Systems POWER Incorporated -2 POWER + 12 VDC - 1 Multimode fiber optic cable DED2500-EM SERIAL TO ETHERNET MEDIA CONVERTER - 10 NO - 9 CONTACT CLOSURE 10 /100 TX COM- 8 NC - 7 2W RS485 (-) - 6 2W RS485 (+)
Initializing the DED2500 Upon power up and network connection into the DED2500, the address factory default is 192.168.1.100. The unit's serial port configuration must be completed prior to physically wiring to the data port. Opening the web browser to the default address, the log on screen will be displayed. LoginID: admin Password: 123456 This will open the network device parameters. Assign a new network address by either user selection or enabling the DHCP.
Intializing the DED 2500 continued. To set up the serial port, select the Serial Port Setup at the top of the Network Setup window. Note: The serial port must be configured prior to physically wiring the data port.
FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesirable operation. Changes or modifications not expressly approved by International Fiber Systems, Inc. could void the user’s authority to operate the equipment.
Contacting us For help installing, operating, maintaining, and troubleshooting this product, refer to this document and any other documentation provided. If you still have questions, contact us during business hours (Monday through Friday, excluding holidays, between 5 a.m. and 5 p.m. Pacific Time). Table 3. Sales and support contact information Sales Phone: Toll-free: 888.437.3287 in the US, including Alaska and Hawaii; Puerto Rico; Canada. Outside the toll-free area: 503.885.5700.
Product Disassembly Instructions for WEEE Per European Directive 2002/95/EC Waste Electrical and Electronic Equipment Required Tools: One number 2 Phillips (crosstip) screwdriver. One number 2 flat screwdriver. For the enclosed box version: 1. Locate and remove box cover securement screws. Usually, but not limited to, at least 4 screws. 2. Lift off box top cover. 3. Locate and remove securement screws for printed circuit board. 4.
Copyright Trademarks and patents Manufacturer Certification FCC compliance ACMA compliance Canada European Union directives © 2011 UTC Fire & Security. All rights reserved. Interlogix and IFS names and logos are trademarks of UTC Fire & Security. Other trade names used in this document may be trademarks or registered trademarks of the manufacturers or vendors of the respective products. UTC Fire & Security Americas Corporation, Inc.
