DE7210M DE7230M IFS EtherNav Installation & Operation Instructions P/N 1062842 • REV B • ISS 01AUG11
DE7200M SERIES 10 / 100 MIDI (Electrical Port) Transmit + (Pin 1) Transmit - (Pin 2) Receive + (Pin 3) Receive - (Pin 6) NOTE: Pins 4, 5, 7, 8 are not used. 10 / 100 MIDIX (Electrical Port) Receive + (Pin 1) Receive - (Pin 2) Transmit + (Pin 3) Transmit - (Pin 6) NOTE: Pins 4, 5, 7, 8 are not used.
DE7230M ETHERNET MEDIA CONVERTER 10/100 TX 10/100TX 100FX TX RX POWER ifs LNK / ACT 24 VAC / GND - 2 24 VAC / + 12 VDC - 1 Singlemode fiber optic cable DE7230M ETHERNET MEDIA CONVERTER 10/100 TX 100FX TX RX POWER ifs LNK / ACT 24 VAC / GND - 2 24 VAC / + 12 VDC - 1 10/100TX
DE7200M SERIES A C B A B C D E F D C F Fiber port Power connection Link Speed Simplex/Duplex Port connection Power E GRN = 100 RED or OFF = 10 GRN or YEL = DUPLEX OFF = SIMPLEX LED illuminates with fiber connection
FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesirable operation. Changes or modifications not expressly approved by International Fiber Systems, Inc. could void the user’s authority to operate the equipment.
Contacting us For help installing, operating, maintaining, and troubleshooting this product, refer to this document and any other documentation provided. If you still have questions, contact us during business hours (Monday through Friday, excluding holidays, between 5 a.m. and 5 p.m. Pacific Time). Sales and support contact information North America Toll-free: 855.286.8889 in the US, including Alaska and Hawaii; Puerto Rico; Canada. Outside the toll-free area: 503.885.5700.
Product Disassembly Instructions for WEEE Per European Directive 2002/95/EC Waste Electrical and Electronic Equipment Required Tools: One number 2 flat screwdriver. For the enclosed box version: 1. Locate and remove box cover securement screws. Usually, but not limited to, at least 1 screw. 2. Lift off box top cover. 3. Locate and remove securement screws for printed circuit board. 4. If there are multiple boards to the assembly, continue removing securement screws until none are left. 5.
Copyright Trademarks and patents Manufacturer Certification ACMA compliance Canada European Union directives © 2011 UTC Fire & Security. All rights reserved. Interlogix and IFS names and logos are trademarks of UTC Fire & Security. Other trade names used in this document may be trademarks or registered trademarks of the manufacturers or vendors of the respective products. UTC Fire & Security Americas Corporation, Inc.
